Infiniti QX56 (JA60). Manual - part 568
GI-46
< BASIC INSPECTION >
CONSULT-III CHECKING SYSTEM
CONSULT-III CHECKING SYSTEM
Description
INFOID:0000000005149609
• When CONSULT-III is connected with a data link connector
equipped on the vehicle side, it will communicate with the control
unit equipped in the vehicle and then enable various kinds of diag-
nostic tests.
• Refer to “CONSULT-III Operation Manual” for more information.
Function and System Application
INFOID:0000000005149610
1
: Hood release handle
2
: Data link connector
ALBIA0047ZZ
Diagnostic test
mode
Function
ENGINE
T
R
ANSMI
SSION
ICC
*1
AB
S
AI
R BAG
IPDM
E/R
BCM
METER/
M&A
INTELLI
G
E
N
T
KEY
AUT
O
DRIVE
POS.
REAR
V
IEW CA
MERA
AIR LEVELIZER
MUL
TI
A
V
ALL MODE
A
W
D/4WD
*2
HV
A
C
SONAR
*3
Work support
This mode enables a technician to adjust some devices
faster and more accurately by following the indications on
CONSULT-III.
x - x x - - x - x x x x - x - -
Self-diagnostic
Self-diagnostic can be performed quickly.
- -
-
- x - - - - - - - -
-
- -
Self-diagnostic re-
sults
Self-diagnostic results can be read and erased quickly.
x x x x - x x x x x - x x x x x
Trouble diagnostic
record
Current self-diagnostic results and all trouble diagnostic
records previously stored can be read.
- -
- - x - - - - - - - -
-
- -
Data monitor
Input/Output data in the ECM can be read.
x x x x - x - x x x x x x x x x
Data monitor (spec)
Data monitor specification can be read.
x -
-
- - - - - - - - - -
-
- -
CAN diagnosis
The condition of CAN communication can be indicated by
a topology.
x x x x x x x x x x - - x x x -
CAN diagnosis sup-
port monitor
The communication condition of CAN communication line
can be read.
x x x x - x x x x x - - x x x -
Active test
Diagnostic Test Mode in which CONSULT-III drives some
actuators apart from the ECMs and also shifts some pa-
rameters in a specified range.
x - x x - x - - x x - x -
-
- -
Function test
This mode can show results of self-diagnosis of ECU with
either “OK” or “NG”. For engines, more practical tests re-
garding sensors/switches and/or actuators are available.
x x x x x - - - x - - - -
-
- -
DTC & SRT confir-
mation
The results of SRT (System Readiness Test) and the self-
diagnosis status/result can be confirmed.
x - x - - - - - x - - - -
-
- -
DTC work support
The operating condition to confirm Diagnosis Trouble
Codes can be selected.
x x x - - - - - x - - - -
-
- -
ECM/ECU part num-
ber
ECM/ECU part number can be read.
x x x x - - x - x x x x x x x x
ECU discriminated
No.
Classification number of a replacement ECU can be read
to prevent an incorrect ECU from being installed.
- -
-
- x - - - - - - - -
-
- -