|
|
Content .. 1232 1233 1234 1235 ..
SRC-140 < DTC/CIRCUIT DIAGNOSIS > B1151 CURTAIN AIR BAG MODULE LH B1151 CURTAIN AIR BAG MODULE LH DTC Logic INFOID:0000000006220082 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refer to SRC-14, "On Board Diagnosis Function" NOTE: Is malfunctioning part detected? YES >> Refer to SRC-140, "Diagnosis Procedure" NO >> INSPECTION END Diagnosis Procedure INFOID:0000000006220083 WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.) • Never use unspecified tester or other measuring device. 1. CHECK HARNESS CONNECTOR Check the harness connector. Is the inspection result normal? YES >> GO TO 2. NO >> Replace harness connector. 2. CHECK WIRING HARNESS Check the wiring harness externals. Is the inspection result normal? YES >> GO TO 3. NO >> Replace wiring harness. 3. REPLACE AIR BAG DIAGNOSIS SENSOR UNIT 1. Replace air bag diagnosis sensor unit. Refer to SR-26, "Removal and Installation" 2. Perform DTC confirmation procedure. Refer to Is DTC detected? YES >> GO TO 4. NO >> INSPECTION END 4. REPLACE REAR CURTAIN AIR BAG MODULE 1. Replace rear curtain air bag module LH. Refer to SR-19, "Removal and Installation" 2. Perform DTC confirmation procedure. Refer to Is DTC detected? YES >> GO TO 1. DTC Display contents of CONSULT-III DTC detecting condition Possible cause B1151 CURTAIN MODULE LH Rear curtain air bag module LH circuit is • Disconnection of wiring harness and short |