|
|
TROUBLE DIAGNOSIS FOR SELF-DIAGNOSTIC ITEMS ACS-65 [ICC] C D E F G H I J L M A B ACS DTC 97 AT CIRCUIT NKS001KU 1. CHECK A/T CIRCUIT With CONSULT-II With TCM diagnosis, check if shift operates normally. Refer to AT-107, "DTC P0705 PARK/NEUTRAL POSI- OK or NG OK >> 1. Replace ICC unit. 2. Erase DTC and perform ICC system running test. Then perform self-diagnosis of ICC system again. NG >> 1. Perform TCM self-diagnosis. 2. After repairing or replacing applicable item, erase DTC and perform ICC system running test. Then perform self-diagnosis of ICC system again. DTC 98 GEAR POSITION NKS001KV 1. PERFORM ICC UNIT SELF-DIAGNOSIS With CONSULT-II 1. Perform self-diagnosis. 2. Check if “DTC 43 ABS/TCS/VDC CIRC” or “DTC 41 VHCL SPEED SE CIRC” other than “DTC 98 GEAR Is any indicated? YES >> 1. Repair or replace applicable item. 2. Erase DTC and perform ICC system running test. Then perform self-diagnosis of ICC system again. NO >> GO TO 2. 2. CHECK VEHICLE SPEED SIGNAL With CONSULT-II With “ICC” “DATA MONITOR”, check if “VHCL SPEED SE” is normal. OK or NG OK >> GO TO 3. NG >> 1. Replace ICC unit. 2. Erase DTC and perform ICC system running test. Then perform self-diagnosis of ICC system again. 3. CHECK SHIFT GEAR POSITION Check that gear positions are correct in A/T. OK or NG OK >> GO TO 5. NG >> GO TO 4. 4. CHECK TCM GEAR POSITION SIGNAL With CONSULT-II With TCM “DATA MONITOR” with CONSULT-II, check if gear positions are correct. OK or NG OK >> 1. Replace ICC unit. 2. Erase DTC and perform ICC system running test. Then perform self-diagnosis of ICC system again. NG >> 1. Perform TCM self-diagnosis. 2. After repairing or replacing applicable item, erase DTC and perform ICC system running test. Then perform self-diagnosis of ICC system again. |