|
|
P0850 PNP SWITCH EC-361 < COMPONENT DIAGNOSIS > [VQ37VHR] C D E F G H I J K L M A EC N P O P0850 PNP SWITCH Description INFOID:0000000001734175 When the selector lever position is P or N (A/T), Neutral position (M/T), park/neutral position (PNP) switch is DTC Logic INFOID:0000000001734176 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. INSPECTION START Do you have CONSULT-III? Do you have CONSULT-III? YES >> GO TO 2. NO >> GO TO 5. 2. PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conduct- Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignition switch OFF and wait at least 10 seconds. >> GO TO 3. 3. CHECK PNP SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “P/N POSI SW” in “DATA MONITOR” mode with CONSULT-III. Then check the “P/N POSI SW” sig- Is the inspection result normal? YES >> GO TO 4. NO >> Go to 4. PERFORM DTC CONFIRMATION PROCEDURE 1. Select “DATA MONITOR” mode with CONSULT-III. 2. Start engine and warm it up to normal operating temperature. 3. Maintain the following conditions for at least 50 consecutive seconds. CAUTION: Always drive vehicle at a safe speed. DTC No. Trouble diagnosis name DTC detecting condition Possible cause P0850 Park/neutral position The signal of the park/neutral position (PNP) • Harness or connectors [The park/neutral position (PNP) switch • Park/neutral position (PNP) switch Position (Selector lever) Known-good signal N or P position (A/T) ON Except above position OFF |