|
|
Content .. 1141 1142 1143 1144 ..
B2603 SHIFT POSITION STATUS SEC-69 < COMPONENT DIAGNOSIS > [INTELLIGENT KEY SYSTEM] C D E F G H I J L M A B SEC N O P B2603 SHIFT POSITION STATUS Description INFOID:0000000001699966 BCM confirms the shift position with the following 4 signals. DTC Logic INFOID:0000000001699967 DTC DETECTION LOGIC NOTE: • If DTC B2603 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Start the engine under the following conditions and wait for at least 1 second. - A/T selector lever is in the P position. - Do not depress the brake pedal. 2. Check “Self diagnostic result” with CONSULT-III. Is DTC detected? YES >> Go to NO >> INSPECTION END Diagnosis Procedure INFOID:0000000001699968 1. CHECK DTC WITH TCM Check “Self diagnostic result” with CONSULT-III. Refer to . Is the inspection result normal? YES >> GO TO 2. NO >> repair or replace the malfunctioning parts. 2. CHECK PNP SWITCH CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect A/T assembly connector and BCM connector M123. 3. Check continuity between A/T assembly harness connector and BCM harness connector. DTC Self-diagnosis name DTC detecting condition Possible causes B2603 SHIFT POSITION STATUS BCM detects the followings status for 500 ms or more when • Harness or connector (A/T device circuit is open or • Harness or connectors [Park/neutral position (PNP) • A/T device (detention switch) • Park/neutral position (PNP) switch |