|
|
ADP-126 < COMPONENT DIAGNOSIS > TILT MOTOR TILT MOTOR Description INFOID:0000000001693770 • The tilt motor is installed on the steering column assembly. Component Function Check INFOID:0000000001693771 1. CHECK FUNCTION 1. Select “TILT MOTOR” in “Active Test” mode with CONSULT-III. 2. Check the tilt motor operation. Is the operation of relevant parts normal? YES >> INSPECTION END NO >> Perform diagnosis procedure. Refer to ADP-126, "Diagnosis Procedure" Diagnosis Procedure INFOID:0000000001693772 1. CHECK TILT MOTOR POWER SUPPLY 1. Turn ignition switch OFF. 2. Disconnect tilt & telescopic motor connector. 3. Turn ignition switch ON. 4. Perform “Active Test” (“TILT MOTOR”) with CONSULT-lll. 5. Check voltage between tilt & telescopic motor harness connector and ground. Is the inspection result normal? YES >> Replace tilt motor. (Built in steering column assembly.) NO >> GO TO 2. 2. CHECK TILT MOTOR CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect automatic drive positioner control unit connector and tilt & telescopic motor connector. 3. Check continuity between automatic drive positioner control unit harness connector and tilt & telescopic Test item Description TILT MOTOR OFF Steering tilt Stop UP Upward DWN Downward Terminal Test item Voltage (V) (Approx.) (+) (-) Tilt & telescopic motor connector Terminal M49 3 Ground TILT MOTOR OFF 0 UP 0 DWN (down) Battery voltage 4 OFF 0 UP Battery voltage DWN (down) 0 |