|
|
Content .. 1273 1274 1275 1276 ..
ST-50 < ON-VEHICLE REPAIR > POWER STEERING OIL PUMP WITH 4WAS : Removal and Installation INFOID:0000000000958687 REMOVAL 1. Drain power steering fluid from reservoir tank. 2. Remove the right half of the air cleaner and the right half of the air duct. Refer to . 3. Loosen drive belt. Refer to EM-12, "Removal and Installation" . 4. Remove drive belt from oil pump pulley. 5. Remove copper washers and eye bolt (drain fluid from their pipings). 6. Remove suction hose (drain fluid from their pipings). 7. Remove oil pump mounting bolts, and then remove oil pump. INSTALLATION Note the following, and install in the reverse order of removal. 1. Pulley 2. Snap ring 3. Drive shaft assembly 4. Bracket 5. Oil seal 6. Connector bolt 7. O-ring 8. Flow control valve 9. Spring 10. Body assembly 11. O-ring 12. Suction pipe 13. O-ring 14. O-ring 15. Side plate 16. Cartridge 17. Vane 18. Rotor 19. Cam ring 20. Dowel pin 21. Gasket 22. Rear cover A: Oil seal lip : Apply power steering fluid. : Apply multi-purpose grease. Refer to for symbols not described on the above. JSGIA0047GB |