Content .. 1209 1210 1211 1212 ..

Infiniti G35 (V35) Sedan. Manual - part 1211

IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)

SEC-199

< ECU DIAGNOSIS >

[INTELLIGENT KEY SYSTEM]

SEC

If No CAN Communication Is Available With BCM

IGNITION RELAY MALFUNCTION DETECTION FUNCTION

• IPDM E/R monitors the voltage at the contact circuit and excitation coil circuit of the ignition relay inside it.
• IPDM E/R judges the ignition relay error if the voltage differs between the contact circuit and the excitation

coil circuit.

• If the ignition relay cannot turn OFF due to contact seizure, it activates the tail lamp relay for 10 minutes to

alert the user to the ignition relay malfunction when the ignition switch is turned OFF.

NOTE:

The tail lamp turns OFF when the ignition switch is turned ON.

FRONT WIPER CONTROL

IPDM E/R detects front wiper stop position by a front wiper auto stop signal.
When a front wiper auto stop signal is in the conditions listed below, IPDM E/R stops power supply to wiper
after repeating a front wiper 10 second activation and 20 second stop five times.

NOTE:

Control part

Fail-safe operation

Cooling fan

• Outputs the pulse duty signal (PWM signal) 100% when the ignition switch is turned

• Outputs the pulse duty signal (PWM signal) 0% when the ignition switch is turned OFF

A/C compressor

A/C relay OFF

Alternator

Outputs the power generation command signal (PWM signal) 0%

Control part

Fail-safe operation

Headlamp

• Turns ON the headlamp low relay when the ignition switch is turned ON
• Turns OFF the headlamp low relay when the ignition switch is turned OFF
• Headlamp high relay OFF

• Parking lamps
• License plate lamps
• Side maker lamps
• Illuminations
• Tail lamps

• Turns ON the tail lamp relay when the ignition switch is turned ON
• Turns OFF the tail lamp relay when the ignition switch is turned OFF

Front wiper

• The status just before activation of fail-safe control is maintained until the ignition

switch is turned OFF while the front wiper is operating at LO or HI speed.

• The wiper is operated at LO speed until the ignition switch is turned OFF if the fail-

safe control is activated while the front wiper is set in the INT mode and the front wiper
motor is operating.

Front fog lamps

Front fog lamp relay OFF

Horn

Horn OFF

Ignition relay

The status just before activation of fail-safe is maintained.

Starter motor

Starter control relay OFF

Steering lock unit

Steering lock relay OFF

DTC

Ignition switch

Ignition relay

Tail lamp relay

—

OFF

—

B2098: IGN RELAY ON

OFF

ON (10 minutes)

B2099: IGN RELAY OFF

OFF

—

Ignition switch

Front wiper switch

Auto stop signal

OFF

Front wiper stop position signal cannot be
input 10 seconds.

The signal does not change for 10 seconds.

SEC-200

< ECU DIAGNOSIS >

[INTELLIGENT KEY SYSTEM]

IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)

This operation status can be confirmed on the IPDM E/R “Data Monitor” that displays “BLOCK” for the item
“WIP PROT” while the wiper is stopped.

STARTER MOTOR PROTECTION FUNCTION

IPDM E/R turns OFF the starter control relay to protect the starter motor when the starter control relay remains
active for 90 seconds.

DTC Index

INFOID:0000000000961496

*1: Only for the models with AFS

*2: Only for the models without AFS (The display is fixed to CRNT until the self-diagnosis results are erased when the malfunctions were
found in the past.)

NOTE:
The details of TIME display are as follows.
• CRNT: The malfunctions that are detected now
• 1 - 39: The number is indicated when it is normal at present and a malfunction was detected in the past. It

increases like 0

→

2 · · · 38

→

39 after returning to the normal condition whenever IGN OFF

→

ON. It is

fixed to 39 until the self-diagnosis results are erased if it is over 39. It returns to 0 when a malfunction is
detected again in the process.

CONSULT display

Fail-safe

TIME

NOTE

Refer to

No DTC is detected.
further testing
may be required.

—

U1000: CAN COMM CIRCUIT

CRNT

1 –39

PCS-15

CRNT

B2098: IGN RELAY ON

CRNT

1 – 39

PCS-16

B2099: IGN RELAY OFF

—

CRNT

1 – 39

PCS-17

B2108: STRG LCK RELAY ON

—

CRNT

1 – 39

SEC-89

B2109: STRG LCK RELAY OFF

—

CRNT

1 – 39

SEC-90

B210A: STRG LCK STATE SW

—

CRNT

1 – 39

SEC-91

B210B: START CONT RLY ON

—

CRNT

1 – 39

SEC-95

B210C: START CONT RLY OFF

—

CRNT

1 – 39

SEC-96

B210D: STARTER RELAY ON

—

CRNT

1 – 39

SEC-97

B210E: STARTER RELAY OFF

—

CRNT

1 – 39

SEC-98

B210F: INTRLCK/PNP SW ON

—

CRNT

1 – 39

SEC-100

B2110: INTRLCK/PNP SW OFF

—

CRNT

1 – 39

SEC-104

INTELLIGENT KEY SYSTEM/ENGINE START FUNCTION SYMPTOMS

SEC-201

< SYMPTOM DIAGNOSIS >

[INTELLIGENT KEY SYSTEM]

SEC

SYMPTOM DIAGNOSIS

INTELLIGENT KEY SYSTEM/ENGINE START FUNCTION SYMPTOMS

Symptom Table

INFOID:0000000000961497

Engine can not be started with all Intelligent Keys.

CAUTION:

• Follow Trouble Diagnosis Flowchart referring to “

SEC-5, "Work Flow"

”. Determine malfunctioning

condition before performing this diagnosis.

• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagno-

sis.

• Check systems shown in the “Diagnosis/service procedure” column in this order.

CONDITIONS OF VEHICLE (OPERATING CONDITIONS)

• Engine start function is ON when setting on CONSULT-III.
• Use Intelligent Key with registered Intelligent Key ID.
• One or more of Intelligent Keys with registered Intelligent Key ID is in the passenger compartment.

Diagnosis/service procedure

Reference page

1. Check power supply and ground circuit

BCM

SEC-107

IPDM E/R

SEC-107

2. Check push button ignition switch

PCS-68

3. Check Intermittent Incident

GI-39