|
|
ADP-86 < COMPONENT DIAGNOSIS > DOOR MIRROR REMOTE CONTROL SWITCH YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT Check continuity between door mirror remote control switch connector and ground. Is the inspection result normal? YES >> GO TO 4. NO >> Repair or replace harness. 4. CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL 1. Connect automatic drive positioner control unit connector. 2. Turn ignition switch ON. 3. Check voltage between automatic drive positioner control unit connector and ground. Is the inspection result normal? YES >> GO TO 5. NO >> Replace automatic drive positioner control unit. Refer to ADP-218, "Removal and Installation" 5. CHECK CHANGEOVER SWITCH Check changeover switch. ADP-86, "CHANGEOVER SWITCH : Component Inspection" . Is the inspection result normal? YES >> Refer to GI-39, "Intermittent Incident" . NO >> Replace door mirror remote control switch. Refer to MIR-68, "Removal and Installation" 6. CHECK INTERMITTENT INCIDENT Check intermittent incident. GI-39, "Intermittent Incident" Is the inspection result normal? YES >> Replace automatic drive positioner control unit. Refer to ADP-218, "Removal and Installation" NO >> Repair or replace the malfunctioning parts. CHANGEOVER SWITCH : Component Inspection INFOID:0000000000960684 1. CHECK CHANGEOVER SWITCH Check door mirror remote control switch. Is the inspection result normal? YES >> INSPECTION END. Door mirror remote control switch connector Terminal Ground Continuity D7 7 Existed Terminals Voltage (V) (Approx.) (+) (-) Automatic drive positioner control unit connector Terminal M51 2 Ground 5 18 Terminal Change over switch condition Continuity Door mirror remote control switch 10 7 LEFT Existed Other than above Not existed 11 RIGHT Existed Other than above Not existed |