|
|
DTC P1421 COLD START CONTROL EC-1045 < SERVICE INFORMATION > [VK45DE] C D E F G H I J K L M A EC N P O DTC P1421 COLD START CONTROL Description INFOID:0000000001326914 ECM controls ignition timing and engine idle speed when engine is started with prewarming up condition. On Board Diagnosis Logic INFOID:0000000001326915 DTC Confirmation Procedure INFOID:0000000001326916 NOTE: least 10 seconds before conducting the next test. • If DTC P1421 is displayed with other DTC, first perform the trouble diagnosis for other DTC. WITH CONSULT-III 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Select “DATA MONITOR” mode with CONSULT-III. 4. Check that the “COOLAN TEMP/S” indication is between 4 ° C (39 ° F) and 36 ° C (97 ° F). If “COOLAN TEMP/S” indication is within the specified value, go to the following step. 5. Start engine and let it idle for 5 minutes. 6. Check 1st trip DTC. 7. If 1st trip DTC is detected, go to EC-1045, "Diagnosis Procedure" WITH GST Follow the procedure “WITH CONSULT-III” above. Diagnosis Procedure INFOID:0000000001326917 1. PERFORM IDLE AIR VOLUME LEARNING Perform EC-663, "Idle Air Volume Learning" . Is Idle Air Volume Learning carried out successfully? Yes or No Yes >> GO TO 2. No >> Follow the instruction of Idle Air Volume Learning. 2. CHECK INTAKE SYSTEM Check for the cause of intake air volume lacking. Refer to the following. OK or NG OK >> GO TO 3. NG >> Repair or replace malfunctioning part 3. CHECK FUEL INJECTION SYSTEM FUNCTION DTC No. Trouble diagnosis name DTC detecting condition Possible cause P1421 Cold start emission reduction ECM does not control ignition timing and engine • Lack of intake air volume |