|
|
Content .. 1301 1302 1303 1304 ..
SEC-108 < COMPONENT DIAGNOSIS > [INTELLIGENT KEY SYSTEM] B210F PNP/CLUTCH INTERLOCK SWITCH B210F PNP/CLUTCH INTERLOCK SWITCH Description INFOID:0000000003586627 IPDM E/R confirms the shift position with the following signals. DTC Logic INFOID:0000000003586628 DTC DETECTION LOGIC NOTE: DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON under the following conditions and wait for at least 1 second. - Selector lever is in the P or N position. - Do not depress brake pedal. 2. Check “Self diagnostic result” with CONSULT-III. Is DTC detected? YES >> Go to SEC-108, "Diagnosis Procedure" . NO >> INSPECTION END Diagnosis Procedure INFOID:0000000003586629 1. CHECK DTC WITH BCM Check “Self diagnostic result” with CONSULT-III. Refer to . Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2. CHECK PNP SWITCH INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect IPDM E/R connector E5. 3. Turn ignition switch ON. 4. Check voltage between IPDM E/R harness connector and ground. Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" NO >> GO TO 3. 3. CHECK PNP SWITCH CIRCUIT 1. Turn ignition switch OFF. DTC No. Trouble diagnosis name DTC detecting condition Possible cause B210F INTER LOCK/PNP SW IPDM E/R detects a mismatch between the sig- • Harness or connectors [Park/neutral position (PNP) switch • Park/neutral position (PNP) switch (+) (–) Condition Voltage (V) (Approx.) IPDM E/R Connector Terminal E5 30 Ground Selector lever P or N Battery voltage Other than above 0 |