|
|
ADP-70 < COMPONENT DIAGNOSIS > TILT SWITCH TILT SWITCH Description INFOID:0000000003134693 Tilt switch is equipped to the steering column. The operation signal is inputted to the automatic drive positioner Component Function Check INFOID:0000000003134694 1. CHECK FUNCTION 1. Turn ignition switch ON. 2. Select “TILT SW-UP”, “TILT SW-DN” in “Data monitor” mode with CONSULT-III. 3. Check tilt switch signal under the following conditions. Is the indication normal? YES >> INSPECTION END NO >> Perform diagnosis procedure. Refer to Diagnosis Procedure INFOID:0000000003134695 1. CHECK TILT SWITCH SIGNAL 1. Turn ignition switch OFF. 2. Disconnect tilt & telescopic switch connector. 3. Turn ignition switch ON. 4. Check voltage between tilt & telescopic switch harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> GO TO 2. 2. CHECK TILT SWITCH CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect automatic drive positioner control unit connector. 3. Check continuity between automatic drive positioner control unit harness connector and tilt & telescopic 4. Check continuity between automatic drive positioner control unit harness connector and ground. Monitor item Condition Status TILT SW-UP Tilt switch (up) Operate ON Release OFF TILT SW-DN Tilt switch (down) Operate ON Release OFF (+) (–) Voltage (V) (Approx.) Tilt & telescopic switch Connector Terminal M31 4 Ground Battery voltage 5 Automatic drive positioner control unit Tilt & telescopic switch Continuity Connector Terminal Connector Terminal M51 1 M31 4 Existed 17 5 |