|
|
ADP-46 < COMPONENT DIAGNOSIS > B2112 SLIDING MOTOR B2112 SLIDING MOTOR Description INFOID:0000000003134649 • The seat sliding motor is installed to the seat cushion frame. DTC Logic INFOID:0000000003134650 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. RERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check “Self diagnostic result” with CONSULT-III. Is the DTC detected? YES >> Perform diagnosis procedure. Refer to NO >> INSPECTION END NOTE: Diagnosis Procedure INFOID:0000000003757155 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check “Self diagnostic result” with CONSULT-III. 3. Erase the DTC. 4. Perform DTC confirmation procedure. Refer to . Is the DTC displayed again? YES >> GO TO 2. NO >> Check intermittent incident. Refer to GI-38, "Intermittent Incident" . 2. CHECK SLIDING MOTOR CIRCUIT (POWER SHORT) 1. Turn ignition switch OFF. 2. Disconnect sliding motor and driver seat control unit connector. 3. Check voltage between sliding motor harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness or connector. 3. CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL 1. Connect driver seat control unit connector. 2. Check voltage between driver seat control unit harness connector and ground. DTC No. Trouble diagnosis name DTC detecting condition Possible cause B2112 SEAT SLIDE The driver seat control unit detects the output of slid- • Driver seat control unit shorted (+) (–) Voltage (V) (Approx.) Sliding motor Connector Terminals B461 35 Ground 0 42 |