|
|
3. Place a bearing cap (1) over the cross end (2) and align cap with yoke bore. 4. Press bearing cap into the yoke bore enough to clear snap ring groove. 5. Repeat Step 3 and Step 4 to install the opposite bearing cap. NOTE: If joint is stiff or binding, strike the yoke 6. Add grease to lube fitting, if equipped. ASSEMBLY - WITH INJECTED RINGS NOTE: Replacement joint has internal snap rings. 1. Place joint in flange with one bearing cap. 2. Position press (3) with receiver (1) on flange and bearing cap (2). HB PROPELLER SHAFT 3 - 15 |