Dodge Dakota (R1). Manual - part 891

 

  Index      Dodge     Dodge Dakota (R1) - service repair manual 2000 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  889  890  891  892   ..

 

 

Dodge Dakota (R1). Manual - part 891

 

 

TEST

ACTION

APPLICABILITY

14

Turn the ignition off to the lock position.
Disconnect the PCM harness connectors.
Check connectors - Clean/repair as necessary
Measure the resistance between the 3-4 Shift Solenoid Control circuit and ground.
Is the resistance below 5.0 ohms?

All

Yes

→

Repair or Replace the Transmission Solenoid Assembly for a short
to ground.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

No

→

Go To

15

15

Turn the ignition off to the lock position.
Disconnect the PCM harness connectors.
Check connectors - Clean/repair as necessary
NOTE: Resistance between the 3-4 Shift Solenoid Control circuit and the
Governor Pressure Solenoid Control circuit should be 28 to 68 ohms.
Measure the resistance between the 3-4 Shift Solenoid Control circuit and the
Governor Pressure Solenoid Control circuit in the PCM harness connector.
NOTE: Resistance between the 3-4 Shift Solenoid Control circuit and the
TCC Solenoid Control circuit should be 50 to 120 ohms.
Measure the resistance between the 3-4 Shift Solenoid Control circuit and the TCC
Solenoid Control circuit in the PCM harness connector.
Is the resistance of both measurements within the specified ranges?

All

Yes

→

Go To

16

No

→

Replace the Transmission Solenoid Assembly in accordance with
the Service Information.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

16

Turn the ignition off to the lock position.
Disconnect the PCM harness connectors.
Remove the Transmission Control Relay.
Check connectors - Clean/repair as necessary
NOTE: Resistance between the 3-4 Shift Solenoid circuit and the circuits
below should be above 100 kohms.
Measure the resistance between the Transmission 3-4 Shift Solenoid Control circuit
and the...
*Sensor Ground circuit in the C2 PCM harness connector.
*Transmission Temp Sensor Signal circuit in the PCM harness connector.
*Governor Pressure Sensor Signal circuit in the PCM harness connector.
*Transmission 5-volt Supply circuit in the C2 PCM harness connector.
Are the resistance values, to any of the listed circuits, below 100 kohms?

All

Yes

→

Replace the Transmission Solenoid Assembly in accordance with
the Service Information.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

No

→

Go To

17

17

If there are no possible causes remaining, view repair.

All

Repair

Replace the Powertrain Control Module in accordance with the
Service Information.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

296

TRANSMISSION

P0753-TRANS 3-4 SHIFT SOL/TRANS RELAY CIRCUITS —

Continued

TEST

ACTION

APPLICABILITY

18

At this time, the conditions required to set the DTC are not present.
NOTE: Use the Freeze Frame Data to help duplicate the conditions that set
the DTC. Pay particular attention to the DTC set conditions, such as, VSS,
MAP, ECT, and Load.
NOTE: Visually inspect the related wiring harness. Look for any chafed,
pierced, pinched, broken, bent, pushed out, corroded terminals, or partially
broken wires.
NOTE: Refer to any technical service bulletins that may apply.
Were any problems found?

All

Yes

→

Repair as necessary.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

No

→

Test Complete.

297

TRANSMISSION

P0753-TRANS 3-4 SHIFT SOL/TRANS RELAY CIRCUITS —

Continued

Symptom:

P0783-3-4 SHIFT SOL, NO RPM DROP AT LOCKUP

When Monitored and Set Condition:

P0783-3-4 SHIFT SOL, NO RPM DROP AT LOCKUP

When Monitored:

Continuously with the key on and the engine running.

Set Condition:

This code will set if the expected engine RPM drop does not occur within

4 seconds of the gear change being requested by the PCM. Three consecutive bad tests are
required to set the code.

POSSIBLE CAUSES

OTHER DTC’S PRESENT

INTERMITTENT 3-4 SOLENOID

FLUID LEVEL AND CONDITION

TRANSMISSION

OIL BURNT OR OIL PAN HAS EXCESSIVE DEBRIS

TEST

ACTION

APPLICABILITY

1

Turn the ignition on.
With the DRBIII

t, read DTCs.

Is the Good Trip Counter for P0783 displayed and equal to 0?

All

Yes

→

Go To

2

No

→

Go To

7

298

TRANSMISSION

TEST

ACTION

APPLICABILITY

2

Turn the ignition on.
With the DRB, read DTCs.
Are any of the following DTCs present?

All

P-1765 Trans 12 V Supply Relay Ctrl Ckt

Refer to the appropriate symptom for diagnostics.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

P-0743 TCC Solenoid/Trans Relay Ckt

Refer to the appropriate symptom for diagnostics.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

P0753-Trans 3-4 Shift Sol/Relay Ckt

Refer to the appropriate symptom for diagnostics.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

P-1899 Park/Neutral Stuck

Refer to the appropriate symptom for diagnostics.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

P-0340 No Cam Signal at PCM

Refer to the appropriate symptom for diagnostics.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

P-0121 TPS Does Not Agree with MAP

Refer to the appropriate symptom for diagnostics.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

P-0122 TPS Low

Refer to the appropriate symptom for diagnostics.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

P-0123 TPS High

Refer to the appropriate symptom for diagnostics.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

No

→

Go To

3

3

Check Transmission fluid level, and condition of the transmission fluid for any
debris.
Is fluid level OK and clear of contamination?

All

Yes

→

Go To

4

No

→

Repair the fluid level and condition as necessary.
Perform TRANSMISSION VERIFICATION TEST VER - 1.

299

TRANSMISSION

P0783-3-4 SHIFT SOL, NO RPM DROP AT LOCKUP —

Continued

 

 

 

 

 

 

 

Content   ..  889  890  891  892   ..