|
|
P0206-FUEL INJECTOR 6 CIRCUIT (CONTINUED) 5. (K58) INJECTOR CONTROL NO.6 CIRCUIT OPEN Turn the ignition off. Disconnect the C2 PCM harness connector. CAUTION: Do not probe the PCM harness connectors. Probing Is the resistance below 5.0 ohms? Yes >> Go To 6 No >> Repair the open in the (K58) Injector Control No.6 circuit. Perform POWERTRAIN VERIFICATION TEST. (Refer to 9 6. PCM NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal Were there any problems found? Yes >> Repair as necessary. Perform (NGC) POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCE- No >> Replace and program the Powertrain Control Module per Service Information. Perform (NGC) POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCE- 9 - 254 ENGINE ELECTRICAL DIAGNOSTICS ND |