|
|
GETTING TO KNOW YOUR VEHICLE 109 4. Watch for the HomeLink indicator to change flash rates. When it changes, it is programmed. It may take up to 30 seconds or longer in rare cases. The garage door may open and close while you are programming. 5. Press and hold the programmed HomeLink button and observe the indicator light. NOTE: •If the indicator light stays on constantly, programming is complete and the garage door/device should acti- vate when the HomeLink button is pressed. • To program the two remaining HomeLink buttons, repeat each step for each remaining button. DO NOT erase the channels. If you unplugged the garage door opener/device for programming, plug it back in at this time. Reprogramming A Single HomeLink Button (Canadian/ Gate Operator) follow these steps: indicator light begins to flash after 20 seconds. Do not release the button. 3. Without releasing the button, proceed with “Canadian/ Gate Operator Programming” step 2 and follow all remaining steps. 2 |