Chrysler Town, Dodge Caravan. Manual - part 807

 

  Index      Chrysler     Chrysler TOWN & COUNTRY, VOYAGER, Dodge Caravan - service repair manual 2001-2007 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  805  806  807  808   ..

 

 

Chrysler Town, Dodge Caravan. Manual - part 807

 

 

Symptom:

LEFT LOW BEAM HEADLAMP CIRCUIT OPEN

POSSIBLE CAUSES

FRONT CONTROL MODULE

GROUND CIRCUIT OPEN

LEFT HEADLAMP

LEFT LOW BEAM DRIVER CIRCUIT OPEN

WIRING HARNESS INSPECTION

TEST

ACTION

APPLICABILITY

1

Turn the ignition on.
With the DRB, erase the Front Control Module DTC’s.
Turn the headlamps on.
Switch the headlamps between high beam and low beam several times, pausing for
5 seconds in each position.
With the DRB, read Front Control Module DTC’s.
Is this DTC present?

All

Yes

→ Go To 2

No

→ Go To 5

2

Turn the ignition off.
Disconnect the Left Headlamp harness connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit.
NOTE: The test light must illuminate brightly. Compare the brightness to
that of a direct connection to the battery.
Does the test light illuminate brightly?

All

Yes

→ Go To 3

No

→ Repair the Ground circuit for an open.

Perform BODY VERIFICATION TEST - VER 1.

3

Turn the ignition off.
Disconnect the Left Headlamp.
Disconnect the Front Control Module from the Intelligent Power Module.
Measure the resistance of the Left Low Beam Driver circuit.
Is the resistance below 10.0 ohms?

All

Yes

→ Go To 4

No

→ Repair the Left Low Beam Driver circuit for an open.

Perform BODY VERIFICATION TEST - VER 1.

464

EXTERIOR LIGHTING

TEST

ACTION

APPLICABILITY

4

Turn the ignition off.
Disconnect the Left Headlamp harness connector.
Using a 12-volt test light connected to ground, check the Left Low Beam Driver
circuit in the Left Headlamp harness connector.
NOTE: The test light must illuminate brightly. Compare the brightness to
that of a direct connection to the battery.
Turn the low beam headlamps on.
Does the test light illuminate brightly?

All

Yes

→ Replace the Left Headlamp Bulb.

Perform BODY VERIFICATION TEST - VER 1.

No

→ Replace the Front Control Module.

Perform BODY VERIFICATION TEST - VER 1.

5

Turn the ignition off.
NOTE: Visually inspect the related wiring harness and circuits. Look for
any chafed, pierced, pinched, or partially broken wires.
NOTE: Visually inspect the related wiring harness connectors. Look for
broken, bent, pushed out, or corroded terminals.
Note: Refer to any Technical Service Bulletins (TSB) that may apply.
Were any problems found?

All

Yes

→ Repair as necessary.

Perform BODY VERIFICATION TEST - VER 1.

No

→ Test Complete.

465

EXTERIOR LIGHTING

LEFT LOW BEAM HEADLAMP CIRCUIT OPEN —

Continued

Symptom:

LEFT LOW BEAM HEADLAMP CIRCUIT SHORTED TO GROUND

POSSIBLE CAUSES

FRONT CONTROL MODULE

LEFT HEADLAMP

LEFT LOW BEAM DRIVER CIRCUIT SHORTED TO GROUND

WIRING PROBLEM

WIRING HARNESS INSPECTION

TEST

ACTION

APPLICABILITY

1

Turn the ignition on.
With the DRB, erase the Front Control Module DTC’s.
Turn the headlamps on.
Switch the headlamps between high beam and low beam several times, pausing for
5 seconds in each position.
With the DRB, read Front Control Module DTC’s.
Is this DTC present?

All

Yes

→ Go To 2

No

→ Go To 5

2

Turn the ignition off.
Disconnect the Left Headlamp.
Disconnect the Front Control Module from the Intelligent Power Module.
Measure the resistance between Ground and the Left Low Beam Driver circuit.
Is the resistance below 100.0 ohms?

All

Yes

→ Repair the Left Low Beam Driver circuit for a short to ground

Perform BODY VERIFICATION TEST - VER 1.

No

→ Go To 3

3

Turn the ignition off.
Turn the Headlamps off.
Install a substitute Headlamp Bulb in place of the Left Headlamp Bulb.
Turn the ignition on.
With the DRB, erase the Front Control Module DTC’s.
Turn the headlamps on.
Switch the headlamps between high beam and low beam several times, pausing for
5 seconds in each position.
With the DRB, read Front Control Module DTC’s.
Does the DRB display this DTC?

All

Yes

→ Go To 4

No

→ Replace the original Left Headlamp Bulb.

Perform BODY VERIFICATION TEST - VER 1.

466

EXTERIOR LIGHTING

TEST

ACTION

APPLICABILITY

4

Turn the ignition off.
Inspect the wiring and connectors associated with the Left Low Beam Driver circuit.
Were any problems found?

All

Yes

→ Repair as necessary.

Perform BODY VERIFICATION TEST - VER 1.

No

→ Test Complete.

5

Turn the ignition off.
NOTE: Visually inspect the related wiring harness and circuits. Look for
any chafed, pierced, pinched, or partially broken wires.
NOTE: Visually inspect the related wiring harness connectors. Look for
broken, bent, pushed out, or corroded terminals.
Note: Refer to any Technical Service Bulletins (TSB) that may apply.
Were any problems found?

All

Yes

→ Repair as necessary.

Perform BODY VERIFICATION TEST - VER 1.

No

→ Test Complete.

467

EXTERIOR LIGHTING

LEFT LOW BEAM HEADLAMP CIRCUIT SHORTED TO GROUND —

Continued

 

 

 

 

 

 

 

Content   ..  805  806  807  808   ..