Chrysler Town, Dodge Caravan. Manual - part 780

 

  Index      Chrysler     Chrysler TOWN & COUNTRY, VOYAGER, Dodge Caravan - service repair manual 2001-2007 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  778  779  780  781   ..

 

 

Chrysler Town, Dodge Caravan. Manual - part 780

 

 

Symptom:

RADIO MEM MSG NOT RECEIVED

When Monitored and Set Condition:

RADIO MEM MSG NOT RECEIVED

When Monitored:

With the ignition in run, and the IOD fuse installed.

Set Condition:

The BCM does not receive any radio memory messages.

POSSIBLE CAUSES

ATTEMPT TO COMMUNICATE WITH THE RADIO

CHECK THE MEMORY SYSTEM

BODY CONTROL MODULE

TEST

ACTION

APPLICABILITY

1

Turn the ignition on.
With the DRB, attempt to communicate with the Radio.
Was the DRB able to I/D or communicate with the Radio?

All

Yes

→ Go To 2

No

→ Refer to the Communication category for the related symptom(s).

Perform BODY VERIFICATION TEST - VER 1.

2

Turn the ignition on.
Operate the memory seat system.
Did the memory seat system operate properly?

All

Yes

→ Go To 3

No

→ Refer to the Memory Seat category and perform the appropriate

symptom.
Perform BODY VERIFICATION TEST - VER 1.

3

With the DRB, erase DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRB, read DTC’s.
Did this DTC reset?

All

Yes

→ Replace the Body Control Module in accordance with the service

information.
Perform BODY VERIFICATION TEST - VER 1.

No

→ Test Complete.

356

COMMUNICATION

Symptom:

RIGHT PSD MESSAGES NOT RECEIVED

When Monitored and Set Condition:

RIGHT PSD MESSAGES NOT RECEIVED

When Monitored:

When the Body Control Module is awake.

Set Condition:

The BCM does not sense a response from the Right Power Sliding Door

Module.

POSSIBLE CAUSES

CHECK FOR DTCS

VERIFY DTC

ATTEMPT TO COMMUNICATE WITH THE RIGHT SLIDING DOOR CONTROL MODULE

BODY CONTROL MODULE

TEST

ACTION

APPLICABILITY

1

Turn the ignition on.
With the DRBIII

t, read BCM DTC’s.

Are any IOD Wakeup power sliding door DTC’s set?

All

Yes

→ Refer to symptom list for problems related to the IOD wakeup

circuit.
Perform BODY VERIFICATION TEST - VER 1.

No

→ Go To 2

2

Turn the ignition on.
With the DRBIII

t, erase DTC’s.

Operate the right power sliding door with either the key fob or the overhead console.
With the DRBIII

t, read BCM DTC’s.

Did this DTC reset?

All

Yes

→ Go To 3

No

→ The condition that caused this DTC is currently not present. Use

the wiring diagrams/schematic as a guide, and inspect the related
wiring harness for a possible intermittent.
Perform BODY VERIFICATION TEST - VER 1.

3

Turn the ignition on.
With the DRB, attempt to communicate with the Right Sliding Door Control Module.
Was the DRB able to I/D or communicate with the Right Sliding Door Control
Module?

All

Yes

→ Go To 4

No

→ Refer to the Communication category for the related symptom(s).

Perform BODY VERIFICATION TEST - VER 1.

357

COMMUNICATION

TEST

ACTION

APPLICABILITY

4

With the DRB, erase DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
Operate the right power sliding door with either the key fob or the overhead console.
With the DRB, read DTC’s.
Did this DTC reset?

All

Yes

→ Replace the Body Control Module in accordance with the service

information.
Perform BODY VERIFICATION TEST - VER 1.

No

→ Test Complete.

358

COMMUNICATION

RIGHT PSD MESSAGES NOT RECEIVED —

Continued

Symptom:

SKIM MESSAGES NOT RECEIVED

When Monitored and Set Condition:

SKIM MESSAGES NOT RECEIVED

When Monitored:

With the ignition in run, and the IOD fuse installed.

Set Condition:

The BCM does not receive any messages from the Sentry Key Immobilizer

Module (SKIM) for at least 5 seconds.

POSSIBLE CAUSES

ATTEMPT TO COMMUNICATE WITH THE SENTRY KEY IMMOBILIZER MODULE

BODY CONTROL MODULE

TEST

ACTION

APPLICABILITY

1

Turn the ignition on.
With the DRB, attempt to communicate with the SKIM.
Was the DRB able to I/D or communicate with the SKIM?

All

Yes

→ Go To 2

No

→ Refer to the Communication category for the related symptom(s).

Perform BODY VERIFICATION TEST - VER 1.

2

With the DRB, erase DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRB, read DTC’s.
Did this DTC reset?

All

Yes

→ Replace the Body Control Module in accordance with the service

information.
Perform BODY VERIFICATION TEST - VER 1.

No

→ Test Complete.

359

COMMUNICATION

 

 

 

 

 

 

 

Content   ..  778  779  780  781   ..