VTSS/SKIS INDICATOR LAMP
DESCRIPTION
The Sentry Key Remote Entry System (SKREES), sometimes referred to as the Sentry Key Immobilizer System
(SKIS), uses an indicator light to convey information on the status of the system to the customer. This light is shared
with the Vehicle Theft Security System (VTSS). The light is located in the instrument panel switch pod, just to the
right of the cluster. The indicator light is controlled by the Cab Compartment Node (CCN), via the Controller Area
Network (CAN) data bus based upon messages it receives from the Sentry Key Remote Entry Module (SKREEM),
sometimes referred to as the Wireless Control Module (WCM),on the CAN data bus, and is hard wired to the clus-
ter.
OPERATION
The VTSS/SKREES lamp is controlled according to Sentry Key Remote Entry Module (SKREEM), sometimes
referred to as the Wireless Control Module (WCM), messages. Then, the SKREEM/WCM sends messages to the
Front Control Module (FCM) to operate the light based upon the results of the SKREES/SKIS self tests. The light
may be actuated in two possible ways, flashing or on solid. If the light comes on and stays on solid after a power-up
test, this indicates that the SKREEM/WCM has detected a system malfunction. If the SKREEM/WCM detects an
invalid key when the ignition switch is moved to the ON position, it sends a message on the CAN bus to the FCM,
to flash the light. The SKREEM/WCM can also send a message to flash the light and generate a single audible
chime at the same time. These two events occurring simultaneously indicate that the SKREES/SKIS has been
placed into the
9
Customer Learn
9
mode (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY/TRANSPONDER
KEY - STANDARD PROCEDURE). If the light comes on and stays on after the power-up test, diagnosis of the
SKREES/SKIS should be performed using a scan tool and the appropriate diagnostic information. The light is not a
serviceable component.
8Q - 148
VEHICLE THEFT SECURITY - SERVICE INFORMATION
LX