Chrysler 300/300 Touring/300C, Dodge Magnum. Manual - part 757

INSTALLATION

MANUAL PASSENGER FRONT SEAT

WARNING: The Seat Weight Sensor is a sensitive,
calibrated unit and must be handled carefully. Do
not drop or handle roughly. If dropped or dam-
aged, replace with another sensor. Failure to do so
may result in occupant injury or death.

WARNING: The front passenger seat must be han-
dled carefully as well. When removing the seat, be
careful when setting on floor not to drop. If
dropped, the sensor may be inoperative, could
result in occupant injury, or possibly death.

WARNING: When the seat is on the floor, no one
should sit in the front passenger seat. This
uneven force may damage the sensing ability of
the seat weight sensors. If sat on and damaged,
the sensor may be inoperative, could result in
occupant injury, or possibly death.

1. Position the seat weight sensor onto passenger front seat riser.

2. Install the two nuts (2) holding the seat weight sensor (4) to the seat riser. Torque nuts to 40 N·m (30 ft. lbs.).

3. Connect the one electrical connector (1).

4. Install the adjuster to riser mounting bolt (3).

Torque nuts to 45 N·m (33 ft. lbs.). For additional
information (Refer to 23 - BODY/SEATS/SEAT
RISER - INSTALLATION).

8O - 434

RESTRAINTS - SERVICE INFORMATION

5. Install the front passenger seat (Refer to 23 -

BODY/SEATS/SEAT - INSTALLATION)

WARNING: Do not connect the battery negative
cable (Refer to 8 - ELECTRICAL/RESTRAINTS -
DIAGNOSIS AND TESTING - AIRBAG SYSTEM).
Personal injury or death may result if the system
test is not performed first.

WARNING: Following successful completion of the
Airbag System test procedure, the Occupant Clas-
sification System Verification Test must be done
using a scan tool and the appropriate diagnostic
information.

POWER FRONT PASSENGER SEAT

NOTE: If the vehicle is equipped with a power
front passenger seat, to remove the adjuster from
the riser it is necessary to have battery power to
move the seat forward and rearward to access the
mounting bolts.

1. Position the seat weight sensor onto passenger

front seat riser.

2. Install the two nuts (2) holding the seat weight sen-

sor (4) to the seat riser. Torque nuts to 40 N·m (30
ft. lbs.).

3. Connect the one electrical connector (1).

RESTRAINTS - SERVICE INFORMATION

8O - 435