|
|
Content .. 1700 1701 1702 1703 ..
INSTALLATION 1. If removed, install the push-pin retainer (2) and a new nut insert (1) into each front fender. NOTE: 300 Shown. Magnum and SRT8 similar. 2. If removed on SRT8 models, install the lower fascia onto the front fascia assembly (4) using new metal 3. If equipped and removed, install the fog lamps onto the front fascia assembly (Refer to 8 - ELECTRI- 4. Position the front fascia assembly to the vehicle and connect each fog lamp wire harness connector 5. If equipped, connect the headlamp washer system hose to washer reservoir. (Refer to 8 - ELECTRI- 6. On all three SRT8 models, connect the Tire Pres- sure Monitoring connector. (Refer to 22 - TIRES/ PRESSURE MONITORING/ TRANSPONDER - REMOVAL) 7. Engage the push-pin retainer (6) into the slot in each side of the front fascia assembly by pushing the fascia rearward. 8. Install the push-pin retainers (2) (four-sedan, six-wagon, eight Charger) that secure the front fascia assembly to the upper radiator support. 9. Raise and support the vehicle. 10. Install the screw (5) that secures the front fascia assembly to the nut insert (1) in each front fender. Tighten the screws securely. 11. Position belly pan to front of vehicle. Install and tighten screws. 13 - 8 FRAME & BUMPERS LX |