|
|
Content .. 1109 1110 1111 1112 ..
3. (N4) FUEL LEVEL SIGNAL CIRCUIT OPEN Turn the ignition off. Disconnect the Fuel Pump Module harness connector. Disconnect the C2 Cluster harness connectors. Measure the resistance of the (N4) Fuel Level Signal circuit from the Is the resistance below 5.0 ohms? Yes >> Go To 4 No >> Repair the open in the (N4) Fuel Level Signal circuit. Perform BODY VERIFICATION TEST-VER 1. (Refer to 8 - CONTROL MODULES/ FRONT CONTROL MODULE - DIAGNOSIS AND TEST- 4. (N4) FUEL LEVEL SIGNAL CIRCUIT SHORTED TO GROUND Measure the resistance between ground and the (N4) Fuel Level Signal Is the resistance below 100 ohms? Yes >> Repair the short to ground in the (N4) Fuel Level Signal cir- cuit. Perform BODY VERIFICATION TEST-VER 1. (Refer to 8 - CONTROL MODULES/ FRONT CONTROL MODULE - DIAGNOSIS AND TEST- No >> Go To 5 9 - 468 ENGINE ELECTRICAL DIAGNOSTICS LX |