|
|
Fig. 156: Locating Transmission Case Bolts 1. Remove 18 bolts (1), one bolt (2), and one bolt (3). NOTE: Refer to Torque Converter Housing/Low and Reverse Clutch
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Automatic Transmission - Allison - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 157: View Of Torque Converter Housing with Fluid Pump Assembly CAUTION: The torque converter housing/oil pump cover assembly dry weights are approximately 27 kg (60 lb). To help avoid
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Automatic Transmission - Allison - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
2. Attach a sling to the converter housing (1). 3. Attach a hoist to the sling. 4. Remove the converter housing/oil pump cover assembly (1) from the transmission case (4) and the turbine shaft (2). 5. Place the converter housing/oil pump cover assembly on the work table. 6. Remove the sling. 7. Remove and discard the main housing/separator plate gasket (3). TRANSMISSION FLUID PAN AND FILTER ASSEMBLY REMOVAL Tools Required J 44587 Main Shaft Holder. See Special Tools. Removal personal injury and/or property damage: Use caution when installing, removing, or moving the Get help when lifting the converter housing/oil pump Assistance from a hoist or another person may be Make sure lifting equipment can properly support the
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Automatic Transmission - Allison - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 158: Identifying J 44587 1. Align J 44587 with the power take-off (PTO) access as follows:. See Special Tools. The tongue of J 44587 is facing toward the PTO access. See Special Tools. NOTE: Do not rotate the transmission from the nose-up position
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Automatic Transmission - Allison - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|
|
|