|
|
Fig. 101: Identifying Main Transmission Connector 3. Push the main transmission connector (2) outward through hole (1) in the transmission case until the retaining feet on the connector are near the locked position.
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Automatic Transmission - Allison - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 102: Using J 44247 To Seat Transmission Connector 4. Use J 44247 to seat the retaining feet on transmission connector (1). See Special Tools. 5. Install the oil pan and transmission internal oil filter. Refer to Oil Pan Replacement. 6. Connect the external wiring harness to the main transmission connector. IMPORTANT: The FastLearn, adapt, procedure must be performed. This can be done in 1 step using a scan tool. If this procedure is
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Automatic Transmission - Allison - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
7. Perform the FastLearn procedure. Refer to FastLearn Procedure. AUTOMATIC TRANSMISSION FLUID PRESSURE TEST HOLE PLUG REPLACEMENT Removal Procedure Fig. 103: View Of Pressure Tap Plug And O-Ring unacceptably long time for the adaptive values to converge
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Automatic Transmission - Allison - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
1. Remove the pressure tap plug (2) and O-ring (1) on the bottom of the converter housing near the transmission external oil filter. 2. Remove the O-ring from the plug and discard it. Installation Procedure Fig. 104: View Of Pressure Tap Plug And O-Ring 1. Install a new O-ring (1) on the pressure tap plug (2). NOTE: Refer to Fastener Notice .
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Automatic Transmission - Allison - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|
|
|