|
|
Fig. 399: View Of Oil Filter 1. Apply clean engine oil to the NEW oil filter gasket. 2. Install the NEW oil filter. Tighten: Tighten the filter after contact plus 1 to 11/4 turn.
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 6.6L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 400: View Of Oil Drain Plug 3. Tighten the oil pan drain plug. Tighten: Tighten the plug to 84 N.m (62 lb ft). 4. Remove the oil drain pan from under the vehicle. 5. Lower the vehicle. 6. Fill the engine with new engine oil. Refer to Approximate Fluid Capacities and Fluid and Lubricant Recommendations . 7. Start the engine. 8. Inspect for oil leaks after engine start up. 9. Turn off the engine and allow the oil a few minutes to drain back into the oil pan.
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 6.6L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
10. Remove the oil level indicator from the oil level indicator tube. 11. Clean off the indicator end of the oil level indicator with a clean paper towel or cloth. 12. Install the oil level indicator into the oil level indicator tube until the oil level indicator handle contacts the top of the oil level indicator tube. 13. Again, remove the oil level indicator from the oil level indicator tube keeping the tip of the oil level indicator down. 14. Check the level of the engine oil on the oil level indicator. 15. If necessary, adjust the oil level be adding or draining oil. 16. Check for oil leaks. OIL PUMP REMOVAL
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 6.6L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 401: Removing/Installing Secondary Oil Pump Driven Gear Nut While Holding NOTE: Do not use an impact driver to remove or install the oil pump IMPORTANT: Look for an "L" on the end of the oil pump shaft. If there is an
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 6.6L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|
|
|