|
|
Content .. 2726 2727 2728 2729 ..
Courtesy of GENERAL MOTORS CORP. 3. Connect the power steering fluid cooler hose (4) to the power steering pump (1). 4. Connect the power steering fluid cooler hose (3) to the steering gear (2). 5. Clean any excess fluid from the vehicle and remove the drain pans. 6. Install the radiator grille. Refer to Radiator Grille Replacement (Chevrolet) or Radiator Grille Replacement (GMC) . 7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding. POWER STEERING GEAR INLET PIPE/HOSE REPLACEMENT (GAS WITH HYDROBOOST) Removal Procedure 1. Install drain pans under the vehicle as needed.
2008 Chevrolet Silverado 1500 2008 STEERING Power Steering - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 70: View Of Power Brake Booster & Power Steering Gear Inlet Hose 2. Remove the power steering gear inlet hose (2) from the power brake booster (1). 3. Remove the power steering gear inlet hose (2) from the power steering gear. 4. Remove the power steering gear inlet hose (2) from the vehicle. Installation Procedure NOTE: Refer to Power Steering Hose Disconnected Notice. IMPORTANT: Note the routing of the power steering gear inlet hose before removal. It MUST be routed correctly upon installation.
2008 Chevrolet Silverado 1500 2008 STEERING Power Steering - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 71: View Of Power Brake Booster & Power Steering Gear Inlet Hose 1. Route the power steering gear inlet hose in the same position it was in prior to removal. NOTE: The inlet and outlet hoses must not be twisted during IMPORTANT: The power steering gear inlet hose cannot be routed between the brake lines and the power brake booster during
2008 Chevrolet Silverado 1500 2008 STEERING Power Steering - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
2. Install the power steering gear inlet hose (2) to the power brake booster (1) and hand tighten only. Rotate the power steering gear inlet hose clockwise until the it contacts the 3. Install the power steering gear inlet hose (2) to the power steering gear. Tighten: Tighten the fittings to 32 N.m (24 lb ft). 4. Clean any excess fluid from the vehicle and remove the drain pans. 5. Fill and bleed the power steering system. Refer to Power Steering System Bleeding. POWER STEERING GEAR INLET PIPE/HOSE REPLACEMENT (GAS WITHOUT HYDRO Fig. 72: View Of Power Steering Gear Inlet Pipe/Hose & Components NOTE: Refer to Fastener Notice . Callout Component Name Preliminary Procedure: Power Steering Gear Inlet Hose Fitting Procedure NOTE: Refer to Fastener Notice .
2008 Chevrolet Silverado 1500 2008 STEERING Power Steering - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Content .. 2726 2727 2728 2729 ..
|
|
|