|
|
Content .. 2555 2556 2557 2558 ..
18. Inspect the gears for spalling. Spalling is extensive triangular pits on the flank, spreading from a zone of gray spots or a 19. If spalling is present, replace the affected components. Spalling is caused by the following conditions: Exceeding the sliding and rolling stresses for the material Incorrect oil viscosity Excessive operating temperature
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (M96) - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 145: Inspect Gears For Overheating 20. Inspect the gears for overheating. Grayish to bluish black discoloration of the gear, burnt oil, and reduced hardness is caused
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (M96) - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
the direction of sliding, particularly in the tip and root zones. If there is extreme 21. If damage from overheating is present, replace or repair the affected components. Overheating is caused by the following conditions: Temporary or complete lack of lubrication - low oil level Very high peripheral speeds Insufficient tooth clearance
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (M96) - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 146: Inspect Selector Teeth Of Gears For Gear Change Damage 22. Inspect the selector teeth of the gears for gear change damage. The tooth edges are worn and chipped and, in some cases, affected by plastic deformation as
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (M96) - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Content .. 2555 2556 2557 2558 ..
|
|
|