|
|
Content .. 2237 2238 2239 2240 ..
Schematic Reference Radio/Navigation System Schematics Connector End View Reference Component Connector End Views Electrical Information Reference Circuit Testing Connector Repairs Testing for Intermittent Conditions and Poor Connections Wiring Repairs Scan Tool Reference Control Module References for scan tool information Circuit/System Testing 1. Verify the system works with a known good remote If the known good remote operates properly, replace the suspect remote. 2. Operate the radio and turn on the rear seat audio (RSA). Verify the remote headphones operate normally. If the remote headphones do not operate properly, go to Video Entertainment 3. Install a scan tool, monitor the button presses in the radio data display. Verify the radio responds to the remote when the buttons are pressed. If the radio does not respond, test the remote infra-red signal circuits for an open, short Repair Procedures Perform the Diagnostic Repair Verification after completing the diagnostic procedure. IMPORTANT: Test or replace the remote batteries before performing the circuit/system test.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Cellular, Entertainment, and Navigation - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Audio System Transceiver Module Replacement Control Module References for radio replacement, setup, and programming VIDEO ENTERTAINMENT SYSTEM WIRELESS HEADPHONE INOPERATIVE Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category. Reference Information Schematic Reference Radio/Navigation System Schematics Connector End View Reference Component Connector End Views Electrical Information Reference Circuit Testing Connector Repairs Testing for Intermittent Conditions and Poor Connections Wiring Repairs Scan Tool Reference Control Module References for scan tool information Circuit/System Testing No Audio From Wireless Headphones IMPORTANT: Center the balance and fade adjustment on the radio. If adjustment of the fade and balance eliminates the concern,
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Cellular, Entertainment, and Navigation - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
1. Turn ON the wireless headphones. Verify the power indicator lamp on the wireless headphone illuminates. If the power indicator lamp does not illuminate on the wireless headphones check or 2. Activate the RSA. Set both wireless headphones to the proper channel to hear RSA. Adjust the volume up on both wireless headphones. Verify that only one set of wireless headphones If only one set of wireless headphones do not have audio, replace the suspect wireless 3. With a DMM, verify there is B+ at the infra-red module supply voltage circuit when the RSA is activated. If B+ is not present, test for a open or short to power on the infra-red module supply 4. At the infra-red module connector harness, test for AC voltage between the low reference circuit and the left and right infra-red audio signal circuits. Verify there is AC voltage with If AC voltage is not present, test for an open, short to ground or short to B+ on the low 5. Ignition OFF, Disconnect the harness connector of the infra-red module. Test for less than 1.0 ohm between the ground circuit terminal 12 and ground. If greater than the specified range, repair the ground circuit. If the ground circuit tests normal, replace the infra-red module. Audio In One Channel of the Wireless Headphones or Distortion 1. Activate the RSA. Set both wireless headphones to the proper channel to hear RSA. Adjust the volume up on both wireless headphones. Verify that only one set of wireless headphones If only one set of wireless headphones is faulty, replace the suspect wireless headphone IMPORTANT: Center the balance and fade adjustment on the radio. If adjustment of the fade and balance eliminates the concern,
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Cellular, Entertainment, and Navigation - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
2. At the infra-red module connector harness, test for AC voltage between the low reference circuit and the left and right infra-red audio signal circuits. Verify there is AC voltage with If AC voltage is not present, test for an open, short to ground or short to B+ on the low 3. Test for an open, short to ground or short to B+ on the low reference and both left and right infra-red audio signal circuits. If the low reference and audio signals test normal replace the infra-red module. Repair Procedures Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Audio System Transceiver Module Replacement REPAIR INSTRUCTIONS MOBILE TELEPHONE MICROPHONE REPLACEMENT
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Cellular, Entertainment, and Navigation - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Content .. 2237 2238 2239 2240 ..
|
|
|