|
|
Content .. 2104 2105 2106 2107 ..
1. Remove the crankshaft position (CKP) sensor bolt (702). 2. Remove the CKP sensor (701). 3. Remove the O-ring (750) from the sensor, as required. IMPORTANT: The crankshaft bearing caps are machined with the Do not use the bearing cap M8 side bolts again.
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 290: Identifying Bearing Cap Bolts & Studs 4. Remove the crankshaft bearing cap M8 bolts (127). 5. Remove the bearing cap M10 bolts (129) and studs (128).
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 291: View Of Crankshaft Bearing Cap Bolts (M10) NOTE: Refer to Fastener Notice .
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
6. Install the J 41818 (2). See Special Tools . Tighten: Tighten the J 41818 (2) bolts to 11 N. See Special Tools .m (100 lb in). 7. Install the J 6125-1B (1) to the J 41818 (2) in order to remove the crankshaft bearing caps. See Special Tools . Fig. 292: View Of Crankshaft Main Bearing Caps 8. Remove the bearing caps.
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Content .. 2104 2105 2106 2107 ..
|
|
|