|
|
Content .. 2029 2030 2031 2032 ..
Fig. 4: View Of Oil Pressure Sensor, Washer And Valve Lifter Oil Filter 1. Apply sealant to the threads of the NEW oil pressure sensor. Refer to Sealers, Adhesives, and Lubricants . 2. If equipped with active fuel management perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and washer (707). Tighten: Tighten the sensor to 35 N.m (26 lb ft). NOTE: Refer to Fastener Notice .
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 5: Removing/Installing Oil Pressure Sensor & Washer 3. If not equipped with active fuel management, perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and washer (707).
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 6: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp 4. Connect the engine harness electrical connector (1) to the oil pressure sensor. Tighten: Tighten the sensor to 35 N.m (26 lb ft). 5. Install the intake manifold. Refer to Intake Manifold Replacement (L92 - First Design)
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
or Intake Manifold Replacement (L92 - Second Design) or Intake Manifold ENGINE OIL LEVEL SENSOR AND/OR SWITCH REPLACEMENT Removal Procedure Fig. 7: View Of Oil Pan Drain Plug & Seal
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Content .. 2029 2030 2031 2032 ..
|
|
|