|
|
Tighten: Tighten the J 23523-F plate bolts to 25 N.m (18 lb ft). 2. Install the J 23523-F screw into the end for the crankshaft. 3. Install the J 23523-F bearing, the washer, and the nut onto the J 23523-F screw. 4. Rotate the J 23523-F nut clockwise until the crankshaft balancer hub is completely seated against the crankshaft position sensor reluctor ring. 6. Remove the J 23523-F . Fig. 674: View Of Crankshaft Pulley & Bolts 7. Install the crankshaft pulley and bolts. Finger tighten all bolts until snug. Tighten: Tighten the crankshaft pulley bolts to 58 N.m (43 lb ft).
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.3L - Sierra & Silverado
Fig. 675: Crankshaft Balancer Washer 8. Ensure that the crown of the crankshaft balancer washer (2) is faced away from the engine.
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.3L - Sierra & Silverado
Fig. 676: View Of Crankshaft Balancer Washer & Bolt 9. Install the crankshaft balancer washer and the bolt. Tighten: Tighten the crankshaft balancer bolt to 95 N.m (70 lb ft). VALVE LIFTER INSTALLATION
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.3L - Sierra & Silverado
Fig. 677: View Of Valve Lifters 1. Apply lubricant GM P/N 12345501 (Canadian P/N 992704) or equivalent, to the valve lifter rollers. 2. Install the valve lifters. IMPORTANT: If reusing the valve lifters, install the valve lifters in the original positions.
2008 Chevrolet Silverado 1500 2008 ENGINE Engine Mechanical - 4.3L - Sierra & Silverado
|
|
|