|
|
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
. Turn the gear to reset the gauge 32. R e driven shaft’s fixing device KA-000-288; . Turn the adjusting bolt clockwise by 270 degree. Then turn the gear until the gauge index is calibrated. Get the reading X; . Install an adjusting washer under the auxiliary back output gear. The washer’s depth is determined by the following formula: 1.75mm-(Xmm-0.06mm) The 1.75mm-(0.46mm-0.06mm) .355mm in accordance with this formula, mong which, 1.75mm and 0.06mm are all adjusting coefficients; . Remove the gauge. Replace the washer on auxiliary back output gear, if necessary. . Knock the flange of the lock bolt on the auxiliary back output gear and sink it into the gear pit. . Install the side cover; . Turn the transmission by 180 degree, as shown by the figure;
bearing and adjusting washer. 31 index to zero; emove th 33 34 S= For example: reading is 0.46mm and then, S= =1 A 35 36 37 38 39. Install the thrust washer, thrust 158 |