|
|
z Shift Valves B or C Stuck 1. Warm up the engine to normal operating temperature (the radiator fan comes on). 2. Check to be sure that the transmission is filled to the proper level, and check for fluid leaks. 3. Drain the ATF (see DRAINING & REFILLING ) through a strainer. Inspect the ATF and strainer for metal debris or burnt fluid. Has the ATF deteriorated? YES: Replace ATF (see DRAINING & REFILLING ), and go to step 4. NO: Go to step 8 . 4. Clear the DTC with the HDS. 5. Test-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop. 6. Retest-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop. 7. Check the OBD STATUS in DTCs MENU for a pass/fail test of code P1734. Did the result indicate a fail? YES: Go to step 8. NO: Intermittent failure, the system is OK at this time, if the tester indicates NOT 8. Clear the DTC with the HDS. 9. Select SHIFT SOL TEST in MISC. TEST MENU, then carry out A/T SHIFT SOL B test in SHIFT SOL TEST MENU with the HDS. Is a clicking sound heard? YES: Go to step 10. NO: Replace shift solenoid valve B (see SHIFT SOLENOID VALVE 10. Select SHIFT SOL TEST in MISC. TEST MENU, then carry out A/T SHIFT SOL C test in SHIFT SOL TEST MENU with the HDS. Is a clicking sound heard? YES: Go to step 11. NO: Replace shift solenoid valve C (see SHIFT SOLENOID VALVE 11. Test-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop. 12. Retest-drive the vehicle in the D position in all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop. 13. Check the OBD STATUS in DTCs MENU for a pass/fail test of code P1734. NOTE: Record all freeze data and review General Troubleshooting Information (see
2004 Acura TSX 2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
|