|
|
Fig. 103: Placing The Clutch Waved-Plate On A Surface Plate, And Setting A Dial Indicator On 2. Find the bottom (D) of a phase difference of the waved-plate, zero the dial indicator and make a reference mark on the bottom of the waved-plate. 3. Rotate the waved-plate about 60-degrees apart from the bottom while holding the waved-plate by its circumference. The dial indicator should be at the top (E) of a phase difference. Do not rotate the waved- 4. Read the dial indicator. The dial indicator reads the phase difference (C) of the waved-plate between bottom and top. Standard: 0.05 mm (0.002 in.) minimum 5. Rotate the waved-plate about 60-degrees. The dial indicator should be at the bottom of a phase difference (F and H), and zero the dial indicator. 6. Measure the phase difference at the other two tops (G and I) of the waved-plate by following steps 3 thru 5.
2004 Acura TSX 2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
|