Acura TSX / Honda Accord CL. Manual - part 258

Fig. 6: Measuring Brake Pedal Free Play 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

 

2004 Acura TSX 

2004 BRAKES Disc - TSX

  

 

Fig. 7: Adjusting Brake Pedal 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

PARKING BRAKE 

1. Pull the parking brake lever with 44 lbs. (20 kg) of force to fully apply the parking brake. The parking 

brake lever should be locked within 6-9 clicks. Adjust the parking brake if the lever clicks are not within 
specification.  

2. Release the parking brake lever fully. Loosen the parking brake adjusting nut, start the engine, and press 

the brake pedal several times to set the self adjusting brake before adjusting the parking brake. 

3.  

Block the front wheels, then raise the rear of the vehicle, and ensure it is securely supported. Ensure the 
parking brake arm "A" on the rear brake caliper contacts the brake caliper pin "B". See Fig. 8 .  

4. Remove the center console. See CENTER CONSOLE under REMOVAL & INSTALLATION. Pull the 

parking brake lever up one click. Tighten the adjusting nut "A" until the parking brakes drag slightly 
when the rear wheels are turned. See Fig. 9 . Release the parking brake lever fully, and check that the 
parking brakes do not drag when the rear wheels are turned. Readjust if necessary. Ensure the parking 
brakes are fully applied when the parking brake lever is pulled up fully. Reinstall the console cover. 

NOTE:

The parking brake arm will only contact the brake caliper pin when the 
parking brake adjusting nut is loosened.

 

2004 Acura TSX 

2004 BRAKES Disc - TSX

  

 

Fig. 8: Identifying Parking Brake Arm 
Courtesy of AMERICAN HONDA MOTOR CO., INC.

 

2004 Acura TSX 

2004 BRAKES Disc - TSX

  

 

Fig. 9: Identifying Parking Brake Adjusting Nut 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

TROUBLE SHOOTING 

BRAKE SYSTEM 

NOTE:

For brake system trouble shooting, see Fig. 1 and Fig. 10 .

 

2004 Acura TSX 

2004 BRAKES Disc - TSX