Acura TSX / Honda Accord CL. Manual - part 198

Note these items during removal:  

z

Using solvent and a brush, wash any oil and dirt off the valve body unit, its lines, and the end of the 
gearbox. Blow dry with compressed air.  

z

Make sure to remove the steering wheel before disconnecting the steering joint. Damage to the cable reel 
can occur.  

1. Drain the power steering fluid. (see FLUID REPLACEMENT ).  

2. Raise the front of vehicle, and support it with safety stands in the proper locations .  

3. Remove the front wheels.  

4. Remove the steering wheel (see STEERING WHEEL REMOVAL ).  

5. Remove the steering joint cover A. 

Fig. 57: Removing The Steering Joint Cover A 

6. Remove the steering joint bolt (A), and disconnect the steering joint by moving the steering joint (B) 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

toward the column. Hold the slider shaft (C) on the column with a piece of wire (D) between the joint 
yoke (E) on the slider shaft to the joint yoke on the upper shaft (see STEERING COLUMN 
REMOVAL AND INSTALLATION ). 

Fig. 58: Holding The Slider Shaft On The Column With A Piece Of Wire 

7. Remove the center guide (A), and discard it. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 59: Removing The Center Guide 

8. Remove the steering joint cover B. Be careful not to damage the mating surface on the joint cover B and 

pinion shaft grommet. Replace the cover seal (C) if necessary.  

9. Remove and discard the cotter pin (A) from the tie rod ball joint nut (B), then loosen the nut. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 60: Separating The Tie-Rod Ball Joint 

10. Separate the tie-rod ball joint and knuckle using the special tool (see BALL JOINT ).  

11. Remove the P/S heat baffle plate (A). 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX