|
|
Faulty push rod seat or lifter plunger Replace plunger or push rod Noisy Valves Improper valve lash Re-adjust valve lash, See ENGINES Worn or dirty valve lifters Clean and/or replace lifters Worn valve guides Replace valve guides, See ENGINES Excessive valve seat or face run-out Reface seats or valve face Worn camshaft lobes Replace camshaft, See ENGINES Loose rocker arm studs Re-tighten rocker arm studs, See ENGINES Bent push rods Replace push rods, See ENGINES Broken valve springs Replace valve springs, See ENGINES Burned,Sticking or Broken Valves Weak valve springs or warped valves Replace valves and/or springs, See ENGINES Improper lifter clearance Re-adjust clearance or replace lifters Worn guides or improper guide clearance Replace valve guides, See ENGINES Out-of-round valve seats or improper seat width Re-grind valve seats Gum deposits on valve stems, seats or guide Remove deposits Improper spark timing Re-adjust spark timing Broken Pistons/Rings Undersize pistons Replace with larger pistons, See ENGINES Wrong piston rings Replace with correct rings, See ENGINES Out-of-round cylinder bore Re-bore cylinder bore Improper connecting rod alignment Remove and realign connecting rods Excessively worn ring grooves Replace pistons, See ENGINES Improperly assembled piston pins Re-assemble pin-to-piston, See ENGINES Insufficient ring gap clearance Install new rings, See ENGINES Engine overheating Check cooling system Incorrect ignition timing Re-adjust ignition timing, See TUNE-UP Excessive Exhaust Noise Leaks at manifold to head, or to pipe Replace manifold or pipe gasket
2007 Acura RL GENERAL INFORMATION Trouble Shooting - Basic Procedures
me
Friday, June 05, 2009 2:26:48 PM Page 19 © 2005 Mitchell Repair Information Company, LLC. |