Content .. 261 262 263 264 ..

Acura CSX. Manual - part 263

ＳＮＲ９ＡＡ１Ｋ７７１０００９０７６１ＦＡＡＴ００

−

YES

DTC P0761:

14-133

13. Check for Temporary DTCs or DTCs with the HDS.

Go to step 8.

Go to step 14.

14. Monitor the OBD STATUS for P0756 or P0757 in the

DTCs MENU with the HDS.

Troubleshooting is complete. If any other

Temporary DTCs or DTCs were indicated in step 13,
go to the indicated DTC’s troubleshooting.

If the HDS indicates FAILED, go to step 8. If

the HDS indicates NOT COMPLETED, go to step 12.

NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot with the HDS, and review
General Troubleshooting Information (see page 14-3).

1. Warm up the engine to normal operating

temperature (the radiator fan comes on).

2. Make sure that the transmission is filled to the

proper level, and check for fluid leaks.

3. Drain the ATF (see step 3 on page 14-232) through a

strainer. Inspect the strainer for metal debris or
excessive clutch material.

Replace the transmission, then go to step 12.

Replace the ATF (see page 14-232), then go to

step 4.

4. Turn the ignition switch to ON (II).

5. Clear the DTC with the HDS.

6. Test-drive the vehicle with the shift lever in D, and

let the transmission shift through all five gears.

7. Monitor the OBD STATUS for P0761 in the DTCs

MENU with the HDS.

Go to step 8.

If the HDS indicates PASSED, intermittent

failure, the system is OK at this time. If the HDS
indicates NOT COMPLETED, go to step 6.

8. Clear the DTC with the HDS.

Shift Solenoid Valve C Stuck OFF

Is DT C P07 56 or P07 57 indicated?

Does the HDS indicate PASSED?

Does the str ainer have metal debr is or excessive
clutch mater ial?

Does the HDS indicate F AILED?

08/08/21 14:42:32 61SNR030_140_0135

−

YES

14-134

Automatic Transmission

9. Select Shift Solenoid Valve C in the Miscellaneous

Test Menu, and check that shift solenoid valve C
operates with the HDS.

Go to step 10.

Replace shift solenoid valve C (see page

14-217), then go to step 12.

10. Test-drive the vehicle with the shift lever in D, and

let the transmission shift through all five gears.

11. Monitor the OBD STATUS for P0761 in the DTCs

MENU with the HDS.

Repair shift valve C, or replace the

transmission, then go to step 12.

If the HDS indicates PASSED, intermittent

failure, the system is OK at this time. If the HDS
indicates NOT COMPLETED, go to step 10.

12. Test-drive the vehicle with the shift lever in D, and

let the transmission shift through all five gears.

13. Check for Temporary DTCs or DTCs with the HDS.

Go to step 8.

Go to step 14.

14. Monitor the OBD STATUS for P0761 in the DTCs

MENU with the HDS.

Troubleshooting is complete. If any other

Temporary DTCs or DTCs were indicated in step 13,
go to the indicated DTC’s troubleshooting.

If the HDS indicates FAILED, go to step 8. If

the HDS indicates NOT COMPLETED, go to step 12.

Is a clicking sound hear d?

Does the HDS indicate F AILED?

Is DT C P07 61 indicated?

Does the HDS indicate PASSED?

08/08/21 14:42:32 61SNR030_140_0136

ＳＮＲ９ＡＡ１Ｋ７７１０００９０７７１ＦＡＡＴ００

−

DTC P0771:

YES

14-135

Shift Solenoid Valve E Stuck OFF

NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot with the HDS, and review
General Troubleshooting Information (see page 14-3).

1. Warm up the engine to normal operating

temperature (the radiator fan comes on).

2. Make sure that the transmission is filled to the

proper level, and check for fluid leaks.

3. Drain the ATF (see step 3 on page 14-232) through a

strainer. Inspect the strainer for metal debris or
excessive clutch material.

Replace the transmission, then go to step 12.

Replace the ATF (see page 14-232), then go to

step 4.

4. Turn the ignition switch to ON (II).

5. Clear the DTC with the HDS.

6. Test-drive the vehicle with the shift lever in D, and

let the transmission shift through all five gears.

7. Monitor the OBD STATUS for P0771 in the DTCs

MENU with the HDS.

Go to step 8.

If the HDS indicates PASSED, intermittent

failure, the system is OK at this time. If the HDS
indicates NOT COMPLETED, go to step 6.

8. Clear the DTC with the HDS.

9. Select Shift Solenoid Valve E in the Miscellaneous

Test Menu, and check that shift solenoid valve E
operates with the HDS.

Go to step 10.

Replace shift solenoid valve E (see page

14-217), then go to step 12.

10. Test-drive the vehicle with the shift lever in D, and

let the transmission shift through all five gears.

11. Monitor the OBD STATUS for P0771 in the DTCs

MENU with the HDS.

Repair shift valve E, or replace the

transmission, then go to step 12.

If the HDS indicates PASSED, intermittent

failure, the system is OK at this time. If the HDS
indicates NOT COMPLETED, go to step 10.

12. Test-drive the vehicle with the shift lever in D, and

let the transmission shift through 1st to 3rd gears,
then drive the vehicle at speeds over 19 mph
(30 km/h) for at least 20 seconds.

Does the str ainer have metal debr is or excessive
clutch mater ial?

Does the HDS indicate F AILED?

Is a clicking sound hear d?

Does the HDS indicate F AILED?

08/08/21 14:42:32 61SNR030_140_0137

ＳＮＲ９ＡＡ１Ｋ７７１０００９０７７６ＦＡＡＴ００

−

YES

DTC P0776:

DTC P0777:

14-136

Automatic Transmission

13. Check for Temporary DTCs or DTCs with the HDS.

Go to step 8.

Go to step 14.

14. Monitor the OBD STATUS for P0771 in the DTCs

MENU with the HDS.

Troubleshooting is complete. If any other

Temporary DTCs or DTCs were indicated in step 13,
go to the indicated DTC’s troubleshooting.

If the HDS indicates FAILED, go to step 8. If

the HDS indicates NOT COMPLETED, go to step 12.

NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot with the HDS, and review
General Troubleshooting Information (see page 14-3).

1. Warm up the engine to normal operating

temperature (the radiator fan comes on).

2. Make sure that the transmission is filled to the

proper level, and check for fluid leaks.

3. Drain the ATF (see step 3 on page 14-232) through a

strainer. Inspect the strainer for metal debris or
excessive clutch material.

Replace the transmission, then go to step 13.

Replace the ATF (see page 14-232), then go to

step 4.

4. Turn the ignition switch to ON (II).

5. Clear the DTC with the HDS.

6. Test-drive the vehicle with the shift lever in D, and

let the transmission shift through all five gears.

7. Monitor the OBD STATUS for P0776 or P0777 in the

DTCs MENU with the HDS.

Go to step 8.

If the HDS indicates PASSED, intermittent

failure, the system is OK at this time. If the HDS
indicates NOT COMPLETED, go to step 6.

8. Clear the DTC with the HDS.

A/T Clutch Pressure Control

Solenoid Valve B Stuck OFF

A/T Clutch Pressure Control

Solenoid Valve B Stuck ON

Is DT C P07 7 1 indicated?

Does the HDS indicate PASSED?

Does the str ainer have metal debr is or excessive
clutch mater ial?

Does the HDS indicate F AILED?

08/08/21 14:42:33 61SNR030_140_0138

Content .. 261 262 263 264 ..