|
|
07 05 06 08 − − − − − − − − YES NO YES NO YES NO YES NO 14-105 INPUT SHAFT (MAINSHAFT) NM (WHT/RED) SG2 (GRN/BLK) INPUT SHAFT (MAINSHAFT) NM (WHT/RED) INPUT SHAFT SG2 (GRN/BLK) PCM CONNECTOR B (44P) SG2 (GRN/BLK) INPUT SHAFT PCM CONNECTOR B (44P) NM (WHT/RED) NM 19. Measure the voltage between input shaft (mainshaft) speed sensor connector terminals Replace the input shaft (mainshaft) speed sensor (see page 14-227), then go to step 26. Go to step 20. 20. Turn the ignition switch to LOCK (0). 21. Jump the SCS line with the HDS. 22. Disconnect PCM connector B (44P). 23. Check for continuity between input shaft (mainshaft) speed sensor connector terminal No. 2 Repair short to body ground in the wire between PCM connector terminal B17 and the input Go to step 24. 24. Check for continuity between PCM connector terminal B33 and input shaft (mainshaft) speed Go to step 25. Repair open in the wire between PCM connector terminal B33 and the input shaft 25. Check for continuity between PCM connector terminal B17 and input shaft (mainshaft) speed Go to step 32. Repair open in the wire between PCM connector terminal B17 and the input shaft Wire side of female terminals Wire side of female terminals Wire side of Terminal side of Wire side of Terminal side of Is ther e about 5 V ? Is ther e continuity? Is ther e continuity? Is ther e continuity? 08/08/21 14:41:05 61SNR030_140_0107 |