Porshe 911 (997). Manual - part 380

Milling off spotwelds on the engine mounting and end plate

2. Mill off spotwelds on the engine mounting and end

plate.

2.1. Mill off spotwelds between the engine mounting, end plate and inner side member in area B using

a spotweld cutter.

Diagnostic system: reading out fault memory and activating systems

Removing side member

1677

Milling off spotwelds on the engine mounting and end plate

3. Mill off spotwelds on rear closing panel.

3.1. Mill off spotwelds between the rear closing panel and inner side member in area C using a spotweld

cutter.

Diagnostic system: reading out fault memory and activating systems

Removing side member

1678

Milling off spotwelds on rear closing panel

4. Mill off spotwelds on outer side member.

4.1. Mill off spotwelds between the outer side member and inner side member in areas D, E, F using a

spotweld cutter. Cut through the shielding gas weld in area G using the parting grinder.

Diagnostic system: reading out fault memory and activating systems

Removing side member

1679

Milling off spotwelds on outer side member

5. Cutting off inner side member

5.1. Cut off the inner side member in area H in front of tailored blank (laser weld) dimension X = 30

mm

 using the body saw.

Diagnostic system: reading out fault memory and activating systems

Removing side member

1680