Model MA TOW Tractor. Manual - part 10

 

  Index      Tractors     Model MA-30, MA-40, MA-50, MA-60, MA-70, MA-80 TOW Tractor - service manual 1995 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  8  9  10  11   ..

 

 

Model MA TOW Tractor. Manual - part 10

 

 

Chapter 1: General Information and Operating Instructions   June 1997           Section 1-2                     p. 7

(c)

Start as slowly as possible to allow any ‘slack’ in towing arrangements to be taken
up.

(d)

Travel at a speed consistent with road and load conditions.

(e)

Slow down and sound the horn when approaching corners and junctions.

(f)

Take all corners wide, especially when towing two wheel steer trailers.

(g)

Always be alert.  Watch out for pedestrian and never drive too close behind other
vehicles.

(h)

Do not carry unauthorized passengers.

(i)

If your trip involves crossing road bridge plates, ensure they are secure and are
strong enough to withstand the combined weight of the tractor and driver, or trailer
and load.

(j)

When approaching the destination, reduce speed sufficiently far away to ensure a
slow, rolling halt.  A sudden halt could cause a load displacement.

(k)

Ensure the trailer’s parking brake is applied by immediately raising drawbar vertically
after disconnecting the trailer coupling.  If no parking brake is fitted, securely chock
the road wheels before disconnecting coupling.

3.

Preventative Maintenance

Maintaining the tractor may, or may not be your responsibility, depending on company
policy.  In either case, maintenance participation, by you (the operator) is advantageous.  It
will enable you to identify the tractor’s components and understand their function so well
that you will be able to report immediately on any mechanical irregularities.

CAUTION: DO NOT ATTEMPT TO CARRY OUR REPAIRS.  LEAVE THIS TO THE
QUALIFIED MAINTENANCE MECHANIC.  REPORT A FAULTY TRACTOR AND DO
NOT USE UNTIL REPAIRED.

Routine maintenance is essential if your tractor is to be an efficient materials handling unit.
Lack of maintenance will result in costly repairs - loss through downtime - and interruptions
in plant operation.

Chapter 1: General Information and Operating Instructions   Dec. 1995           Section 1-2                     p. 8

(This Page Intentionally Left Blank)

Chapter 1: General Information and Operating Instructions   June 1997           Section 1-3                     p. 1

III.

SPECIFICATIONS AND CAPABILITIES

A.

DIMENSIONS

Length, excluding coupler ............................................................................... 102 inches (259 cm)
Width,  overall .................................................................................................... 57 inches (140 cm)
Height, overall, without cab ............................................................................... 60 inches (152 cm)
Wheelbase ........................................................................................................ 59 inches (150 cm)
Drive Axle under clearance ........................................................................... 5 1/2 inches (014 cm)
Steer Axle under clearance (minimum ground clearance) ............................ 7 3/4 inches (020 cm)
Frame under clearance ..................................................................................... 10 inches (025 cm)
Ramp break-over angle ............................................................................................................. 28°
Angle of approach ...................................................................................................................... 35°
Angle of departure ..................................................................................................................... 40°
Turning radius .................................................................................................. 115 inches (292 cm)
Normal operating weight ............................................................... 4500-5450-6200-7500-8400 lbs.
Drawbar pull .................................................................................. 3000-4000-5000-6000-7000 lbs.
Maximum gross load (Pull) (Based on a maximum O% grade) ...... 60K-80K-100K-120K-150K lbs.
Stopping distance:

15 m.p.h. (5000 dbp Tug & load = 50,000) 113 feet (34.4 m)
10 m.p.h. (5000 dbp Tug & load = 75,000 ) 51 feet (15.6 m)
 5 m.p.h. (5000 dbp Tug & load = 75,000) feet ( 2.1 m)

B.

ENGINE

1.

Gasoline

(a)

Tractors 0001 - 0084

Type .................................................................................. Chrysler Slant Six; 225 CID

(b)

Tractors 0085 through 0363

Type .............................................................. Ford In-Line, 6-cylinder Overhead Valve
Fuel ........................................................................ Gasoline -Regular: 90 - 94 Octane
Bore and Stroke .......................................................................................... 4.00 x 3.18
Displacement .................................................................................... 240 Cubic Inches
Governed R.P.M.. (Full Load) ...................................................................... 2500 RPM
Net Brake HP at Governed RPM .............................................................................. 78
Torque at 2000 RPM ...................................................................................... 170 ft/lbs
Compression Ratio ............................................................................................... 8.9:1
Compression Pressure (psi) ............................................................................ 150-200
Oil Capacity ............................................................................ 7 qts (dry) - 6 qts (refill)
Spark Plugs .......................................................................................................... 18 M
Firing Order ................................................................................................ 1-5-3-6-2-4
Idle Speed RPM .............................................................................................. 500-550
Manifold vacuum at idle minimum (inches of mercury) ............................................ 17
Initial ignition timing-B.T.D.C. ................................................................................... 6°
Oil pressure-hot at 2000 RPM ........................................................................... 35 - 60

Chapter 1: General Information and Operating Instructions   June 1997           Section 1-3                     p. 2

III.

SPECIFICATIONS AND CAPABILITIES

B.

ENGINE

1.

Gasoline (cont)

(b)

Tractors 0362 and up

Type ......................................................................... In-line, 6-Cylinder Overhead Valv
Fuel ............................................................................................... Gasoline -Unleaded
Bore and Stroke .......................................................................................... 4.00 x 3.96
Displacement .................................................................................... 300 Cubic Inches
Governed RPM (full load) ..................................................................................... 2500
Net Brake HP at Governed RPM .............................................................................. 95
Torque at 2000 RPM ............................................................................................... 225
Compression Ratio ............................................................................................... 7.9:1
Compression Pressure (psi) .......................................................................... 150 - 200
Oil Capacity ............................................................................ 7 qts (dry) - 6 qts (refill)
Spark Plugs ....................................................................................................... 18 mm
Firing Order ................................................................................................ 1-5-3-6-2-4
Idle Speed RPM .............................................................................................. 500-550
Manifold Vacuum at Idle Minimum (inches of Mercury) ........................................... 17
Initial Ignition Timing-B.T.D.C ................................................................................... 6°
Oil Pressure-Hot at 2000 RPM .......................................................................... 35 - 60

NOTE:  See Ford Maintenance and Operators Manual for detailed engine data.

2.

Diesel, Perkins 4.236

Type ............................................................................................................ In-line 4 Cylinder
Fuel .............................................................................................................................. Diesel
Displacement ................................................................................................................... 236
Governed RPM .............................................................................................................. 2500
Net Brake HP at Governed RPN ........................................................................................ 77
Torque at 2000 RPM .................................................................................... 180 foot-pounds
Compression Ratio .......................................................................................................... 16:1

3.

Diesel, Perkins 1000-4

Type ............................................................................................................ In-line 4 Cylinder
Fuel .............................................................................................................................. Diesel
Displacement .............................................................................................. 243 cubic inches
Governed RPM .............................................................................................................. 2500
Net Brake HP at Governed RPN ........................................................................................ 80
Torque at 2000 RPM .................................................................................... 192 foot-pounds
Compression Ratio .......................................................................................................... 16:1

 

 

 

 

 

 

 

Content   ..  8  9  10  11   ..