|
|
❑ Check for damage and correct seating 10 - Brake Carrier ❑ Supplied as an assembled replacement part with sufficient grease on guide pins pins 2.2 Brake Caliper Piston, Removing and In‐ stalling ⇒ “2.2.1 Brake Caliper Piston, Removing and Installing”, page 103 2.2.1 Brake Caliper Piston, Removing and In‐ stalling Special tools and workshop equipment required WARNING Adjust the brake piston is permitted only with the Brake Caliper Tool - T10165- . – Install the Brake Caliper Tool - T10165- so that the collar touches the piston. – Remove piston from brake caliper by turning knurled wheel toward left. – For pistons that are difficult to move, an open-end wrench (size 13 mm) can be applied at the appropriate wrench surface -arrow A-. – Remove the sealing ring using the Trim Removal Wedge - 3409- . |