|
|
Content .. 1075 1076 1077 1078 ..
TM-206 < COMPONENT DIAGNOSIS > [5AT: RE5R05A] P1772 LOW COAST BRAKE SOLENOID P1772 LOW COAST BRAKE SOLENOID Description INFOID:0000000005274136 Low coast brake solenoid valve is turned “ON” or “OFF” by the TCM in response to signals sent from the trans- CONSULT-III Reference Value in Data Monitor Mode INFOID:0000000005274137 On Board Diagnosis Logic INFOID:0000000005274138 • This is an OBD-II self-diagnostic item. when TCM detects an improper voltage drop when it tries to operate the solenoid valve. Possible Cause INFOID:0000000005274139 • Harness or connectors (The solenoid circuit is open or shorted.) • Low coast brake solenoid valve DTC Confirmation Procedure INFOID:0000000005274140 NOTE: WITH CONSULT-III 1. Turn ignition switch “ON”. (Do not start engine.) 2. Select “DATA MONITOR” mode for “ENGINE” with CONSULT-III. 3. Start engine. 4. Drive vehicle and maintain the following conditions for at least 5 consecutive seconds. 5. If DTC is detected, go to . WITH GST Follow the procedure “WITH CONSULT-III”. Diagnosis Procedure INFOID:0000000005274141 1. CHECK INPUT SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “SELECTION FROM MENU” in “DATA MONITOR” mode for “TRANSMISSION” with CONSULT-III. 3. Start the engine. 4. Read out the value of “ON OFF SOL” while driving. OK or NG OK >> GO TO 4. NG >> GO TO 2. 2. CHECK TCM POWER SUPPLY AND GROUND CIRCUIT Check TCM power supply and ground circuit. Refer to Item name Condition Display value ON OFF SOL Low coast brake engaged. Refer to ON Low coast brake disengaged. Refer to . OFF |