|
|
WW-34 < DTC/CIRCUIT DIAGNOSIS > FRONT WIPER AUTO STOP SIGNAL CIRCUIT FRONT WIPER AUTO STOP SIGNAL CIRCUIT Component Function Check INFOID:0000000009269566 1. CHECK FRONT WIPER (AUTO STOP) SIGNAL 1. Select FR WIPER STOP of BCM (WIPER) data monitor item. 2. Operate the front wiper. 3. Check that FR WIPER STOP changes from ON to OFF according to the wiper position. Is the inspection result normal? YES >> Front wiper auto stop signal circuit is normal. NO >> Refer to . Diagnosis Procedure INFOID:0000000009269567 Regarding Wiring Diagram information, refer to . 1. CHECK FRONT WIPER MOTOR (AUTO STOP) OUTPUT VOLTAGE 1. Turn the ignition switch ON. 2. Check voltage between IPDM E/R harness connector and ground. Is the inspection result normal? YES >> Check for intermittent failure. NO >> GO TO 2 2. CHECK FRONT WIPER MOTOR (AUTO STOP) SHORT CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect IPDM E/R and front wiper motor. 3. Check continuity between IPDM E/R harness connector and ground. Is the inspection result normal? YES >> Repair or replace harness. NO >> GO TO 3. 3. CHECK FRONT WIPER MOTOR (AUTO STOP) CIRCUIT CONTINUITY Check continuity between IPDM E/R harness connector and front wiper motor harness connector. Data monitor Condition Status FR WIPER STOP Front wiper motor Stop position ON Except stop position OFF Terminals FRONT WIPER Voltage (Approx.) (+) (-) IPDM E/R Ground Connector Terminal E46 74 Except stop position Battery voltage Stop position 0 V IPDM E/R Ground Continuity Connector Terminal E46 74 No |