|
|
SEC-140 < DTC/CIRCUIT DIAGNOSIS > [WITHOUT INTELLIGENT KEY SYSTEM] B2195 ANTI-SCANNING B2195 ANTI-SCANNING DTC Logic INFOID:0000000009268495 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT. YES >> Refer to SEC-140, "Diagnosis Procedure" NO >> Inspection End. Diagnosis Procedure INFOID:0000000009268496 1. CHECK SELF DIAGNOSTIC RESULT 1 1. Select “Self Diagnostic Result” of “BCM” using CONSULT. 2. Erase DTC. 3. Perform DTC Confirmation Procedure for DTC P2195. Refer to . Is DTC detected? YES >> GO TO 2. NO >> Inspection End. 2. CHECK EQUIPMENT OF THE VEHICLE Check that unspecified accessory part related to engine start is not installed. YES >> GO TO 3. NO >> GO TO 4. 3. CHECK SELF DIAGNOSTIC RESULT 2 1. Obtain the customer’s approval to remove unspecified accessory part related to engine start, and then remove it. 2. Select “Self Diagnostic Result” of “BCM” using CONSULT. 3. Erase DTC. 4. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to . Is DTC detected? YES >> GO TO 4. NO >> Inspection End. 4. REPLACE BCM 1. Replace BCM. Refer to BCS-122, "Removal and Installation" . 2. Perform initialization of BCM and registration of all ignition keys using CONSULT. For initialization and registration procedures, refer to CONSULT Immobilizer mode and follow the on- screen instructions. >> Inspection End. DTC No. Trouble diagnosis name DTC detecting condition Possible cause B2195 ANTI SCANNING ID verification between BCM and ECM is detect- ID verification request out of specifi- |