|
|
SEC-84 < DTC/CIRCUIT DIAGNOSIS > [WITH INTELLIGENT KEY SYSTEM] B2608 STARTER RELAY 3. CHECK STARTER RELAY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect starter relay. 3. Disconnect BCM connector. 4. Check continuity between starter relay harness connector and BCM harness connector. 5. Check continuity between starter relay harness connector and ground. Is the inspection result normal? YES >> GO TO 5. NO >> Repair or replace harness. 4. CHECK STARTER RELAY SEC-84, "Component Inspection" . Is the inspection result normal? YES >> GO TO 5. NO >> Replace starter relay. 5. REPLACE BCM 1. Replace BCM. Refer to BCS-69, "Removal and Installation" . 2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT. 3. Perform DTC CONFIRMATION PROCEDURE for B2605. Refer to . Is DTC B2605 detected again? YES >> Replace IPDM E/R. Refer to PCS-30, "Removal and Installation" NO >> Inspection End. Component Inspection INFOID:0000000009268426 1. CHECK STARTER RELAY 1. Turn ignition switch OFF. 2. Disconnect starter relay. 3. Check continuity between starter relay terminals. Is the inspection result normal? YES >> Inspection End. NO >> Replace starter relay. Starter relay BCM Continuity Connector Terminal Connector Terminal E41 1 M98 97 Yes Starter relay Ground Continuity Connector Terminal E41 1 No Starter relay Condition Continuity Terminal 3 5 12 V direct current supply between terminals 1 and 2 Yes No current supply No |