|
|
|
PRECAUTIONS GW-3 < PRECAUTION > C D E F G H I J L M A B GW N O P Precaution for Work INFOID:0000000009267742 • When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth. • When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component with a shop cloth or vinyl tape to protect it. • Protect the removed parts with a shop cloth and prevent them from being dropped. • Replace a deformed or damaged clip. • If a part is specified as a non-reusable part, always replace it with a new one. • Be sure to tighten bolts and nuts securely to the specified torque. • After installation is complete, be sure to check that each part works properly. • Follow the steps below to clean components: - Water soluble dirt: • Dip a soft cloth into lukewarm water, wring the water out of the cloth and wipe the dirty area. • Then rub with a soft, dry cloth. - Oily dirt: • Dip a soft cloth into lukewarm water with mild detergent (concentration: within 2 to 3%) and wipe the dirty area. • Then dip a cloth into fresh water, wring the water out of the cloth and wipe the detergent off. • Then rub with a soft, dry cloth. - Do not use organic solvent such as thinner, benzene, alcohol or gasoline. - For genuine leather seats, use a genuine leather seat cleaner. |