|
|
EC-434 [QG (WITH EURO-OBD)] DTC P1146 HO2S2 (M/T MODELS) WITH CONSULT-II Procedure for COND1 For the best results, perform “DTC WORK SUPPORT” at a temperature of 0 to 30 ° C (32 to 86 ° F). 1. Start engine and warm it up to the normal operating temperature. 2. Turn ignition switch “OFF” and wait at least 10 seconds. 3. Start engine and keep the engine speed between 3,500 and 4,000 rpm for at least one minute under no 4. Let engine idle for one minute. 5. Select “HO2S2 (B1) P1146” of “HO2S2” in “DTC WORK SUPPORT” mode with CONSULT-II. 6. Touch START”. 7. Let it idle for at least 30 seconds. 8. Rev engine up to 2,000 rpm 2 or 3 times quickly under no load. 9. When the following conditions are met, “TESTING” will be displayed at “COND1” on the CONSULT-II NOTE: ● If “TESTING” is not displayed after 5 minutes, retry from step 2 in “Procedure for COND1”. ● If “COMPLETED” already appears at “COND2” on CONSULT-II screen before “Procedure for Procedure for COND2 1. While driving, release accelerator pedal completed from the NOTE: ENG SPEED More than 1,000 rpm B/FUEL SCHDL More than 1.0 msec COOLANT TEMP/S 70 - 105 ° C Selector lever Suitable position PBIB0555E PBIB0556E |