Nissan Almera Tino V10. Manual - part 92
AT-92
[EURO-OBD]
TROUBLE DIAGNOSIS — GENERAL DESCRIPTION
Too high a gear change point from
“D
1
” to “D
2
”, from “D
2
” to “D
3
”,
from “D
3
” to “D
4
”.
AT-225, "9. A/T Does Not Shift: D
and
ON vehicle
1.Throttle position sensor [Accelerator pedal
position (APP) sensor]
AT-183, "DTC P1705
ACCELERATOR PEDAL
POSITION (APP) SEN-
SOR"
2. Vehicle speed sensor·A/T (Revolution
sensor) and vehicle speed sensor·MTR
AT-125, "DTC P0720 VEHI-
CLE SPEED SENSOR A/T
(REVOLUTION SEN-
SOR)"
3. Shift solenoid valve A
AT-173, "DTC P0750
SHIFT SOLENOID VALVE
A"
4. Shift solenoid valve B
AT-178, "DTC P0755
SHIFT SOLENOID VALVE
B"
Gear change directly from “D
1
” to
“D
3
” occurs.
ON vehicle
1. Fluid level
2. Accumulator servo release
AT-410, "Control Valve
Assembly and Accumula-
tors"
OFF vehicle
3. Brake band
AT-487, "Band Servo Pis-
ton Assembly"
Engine stops when shifting lever
into “R”, “D”, “2” and “1”.
ON vehicle
1. Engine idling rpm
EC-48, "Idle Speed and
Ignition Timing Check"
(With EURO-OBD),
575, "Idle Speed and Igni-
tion Timing Check"
(With-
out EURO-OBD)
2. Torque converter clutch solenoid valve
AT-161, "DTC P0740
TORQUE CONVERTER
CLUTCH SOLENOID
VALVE"
3. Control valve assembly
AT-410, "Control Valve
Assembly and Accumula-
tors"
OFF vehicle
4. Torque converter
AT-421, "Locations of
Adjusting Shims, Needle
Bearings, Thrust Washers
and Snap Rings"
Symptom
Condition
Diagnostic Item
Reference Page
EURO-OBD